©Copyright 2017 Axiomtek Co., Ltd.
Version A2 May 2017
Printed in Tai an
9416K100010E
2
I/O Outlets
The following figures show I/O outlets on the eBOX100-312-FL.
Front View
Rear View
1
2 x USB 2.0 7
ATX/AT quick switch
2
1 x swappable HDD drive bay 8
12VDC power input
3
1 x Power button 9
2 x HDMI
4
1 x Remote PWR switch 10
1 x Serial port
5
2 x LEDs for HDD and Power 11
2 x USB 2.0
2 x USB 3.0
6
1 x Reset switch 12
2 x GbE LAN Port
©
Copyright 2017 Axiomtek Co., Ltd.
Version A2 May 2017
Printed in Tai an
9416K100010E
3
Installation of Hard Disk Drive
Step 1 Turn off the system, and unplug the power adaptor.
Step 2 Turn the system upside down to locate screws at the bottom,
and then loosen all screws.
Step 3 Open the bottom cover.
※Put the HDD rubber on bottom cover when customer uses the 7.5
mm thick SSD.
Step 4 Locate SSD/HDD within the red line as marked.
Step 5 Before assemble the SSD/HDD, please loosen the thumb
screw to remove the HDD bracket, and then assemble the
SSD/HDD with the one HDD mounting screw.
Step 6 Put the bottom cover back and fasten all the screws.
Step 7 Turn the system up and then connected the SSD/HDD directly
and make sure the insertion is complete.
