Axminster NV 750s User manual

Owner Instructions
Warning!
Read instructions before using the machine
www.numatic.com
NV 750s
NVD 750s

750 Fitting the handle
1 2
3
4
x4
x4
10mm

Utility Vac Kit 1
NV 750 - Side Inlet for Shavings and Chippings
603917
603101
NV 750, 51mm
Fit the 51mm hose to the side inlet
Fit Stainless gulper to hose if required.
Shavings and Chippings.
Using Blanking Cap attached to machine, to
blank off centre inlet.
NV 750, 51mm
Fit the 51mm hose to the centre inlet.
Fit Stainless gulper to hose if required.
Normal Pick Up.
Using Blanking Cap attached to machine, to
blank off side inlet.
NV 750
NV 750 - Centre Inlet for Normal Pick Up

NVD 750 - 100mm Hose Attachment for Shavings and Chippings
Utility Vac Kit 2
NVD 750
613001
601102
601176
NVD 750, 100mm
Fit (613001) hose securely to make sure there
is a good seal on to the side inlet.
Shavings and Chippings.
Using blanking cap attached to machine, to
blank off centre inlet and remove 51mm
reducer if tted.
NVD 750, 32mm
Fit the (601176) 32mm reducer to the end of
the hose and trim to t your power tool.
Normal Pick Up and Power Tools.
Fit the yellow 32mm reducer and blanking cap
to side entry and then t the (601102) 32 mm
hose to the centre inlet
NVD 750 - 32mm Hose Attachment for Normal Pick Up and Power Tools
(Circular saw show for demonstration purposes)

Using your Machine
Turn on your machine
Make sure your machine is plugged into a
suitable power supply.
NV 750 Blower Cap
Make sure the air diffuser is tted to the rear of your machine.
NVD 750 Blower Cap
Fit the air diffuser before using your machine.
Remove blanking cap, before use and

NVD 750 only - Low Flow Indicator
The NVD appliance is tted with a low ow indicator to show that air ow has
reduced. In the event of the indicator light ashing, check the following:-
Cause Solution
Blanking cap still tted Remove the cap.
Blocked hose Unblock the hose.
Bag full Remove and replace.
Cloth lter clogged Remove and clean.
Cleaning the Machine.
1 1
2
Undo the toggle clamps and remove the head

Remove the Filter
Fitting the Filter bag - Side inlet - Chipping and Shavings
NVD 750NV 750
Place the cut bag into the drum, ret the cloth
lter and ret the machine head.
Shavings and Chippings.
Cut 4BH lter bag.
Undo the locking toggle to
remove the drum from the frame
for emptying.
Remove the used lter bag and empty the contents into a
suitable waste bag, dispose of in an environmentally - friendly
manner.
Removing the Filter bag - Side inlet - Chipping and Shavings
380mm

Fitting the Filter bag - Centre inlet - Normal Pick Up and Power Tools
Ret cloth lter and ret machine head.
Normal Pick up and Power Tools
Fit the new 4BH lter bag over the inlet tube.
The drum should be empty as all the waste is
collected in the 4BH lter bag.
Remove the used lter bag and dispose of in an
environmentally - friendly manner.
Removing the Filter bag - Centre inlet - Normal Pick Up and Power Tools
NV 750 - Single Motor Power NVD 750 - Twin Motor Power.
Axminster Power Tools - Workshop utility vacuum

1 2
Changing the cable
3 4
56
78

About your machine
1
2
3
4
5
6
7
8
9
10
Safety Critical Components
Mains leads:
(230V) NV 750 HO5VV-F 12.5 x 3 x 1.0 mm2 (220950)
(230V) NVD 750 HO5VV-F 10 x 3 x 1.5 mm2 (236011)
(110V) HO5VV-F 12.5 x 3 x 2.5 mm2 (220911)
Failure to rectify the problem or in the event of a breakdown contact your Numatic dealer
or the Numatic Technical helpline [phone].
Daily
Keep the machine clean, including hoses and tubes.
Ensure the bag and lter are tted.
Regularly examine the power cord.
Check dust bag frequently.
Check lters are clean.
Weekly - as daily and:-
Check for any worn or damaged parts and replace immediately.
Do not steam clean or pressure wash.
WEEE Legislation
(Waste, Electrical and Electronic Equipment)
Vacuum cleaner, accessories and packaging should be sorted for environmentally -
friendly recycling.
(Only for EU Countries)
Do not dispose of vacuum cleaner into household waste! According to the
European Directive 2012/19/EU on waste electrical and electronic equipment
and its incorporation into national law.
Vacuum cleaners that are no longer suitable for use must be separately
collected and sent for recovery in an environmentally - friendly manner.
Voltage
Frequency
Rated Input Power
Weight (ready to work)
Company Name & Address
Model
Machine yr/wk Serial number
WEEE Logo
Protection Class
CE Mark
Ear Protection Safety Footwear Head Protection Safety Gloves Eye Protection Protective
Clothing
NOTE: A risk assessment should be conducted to determine which PPE should be worn.
Dust / Allergens
Protection Caution Floor Sign
Hi Vis Jacket
PPE (personal protective equipment) That may be required for certain operations.
5
6
1
2
3
4
7
8
9
10

Information for dry use vacuum cleaners
Caution
This machine must not be stored outside, or used in wet environments, or to collect wet
materials.
The vacuum cleaner should be stored in a dry place and is for indoor use only.
Notes
You must ensure that the ltration system tted to the machine is suitable for the material
being collected.
This product complies with the requirements of IEC/EN 60335-2-69 2012.
The primary use for this machine is commercial, for example in hotels, schools, hospitals,
factories, shops and ofces.
If the vacuum cleaner stops working, remove the plug from the wall before investigating
where the fault lies.
If the vacuum cleaner has a blockage, switch off, remove the plug from the socket outlet,
and inspect the oor tool, wands and hose for debris. If the oor tool, wands and hose are
clear, replace the dust bag and clean the lter.
The vacuum cleaner should be inspected after use for damage.
Warning!
Ensure you read the instruction manual before using the machine.
Operators shall be adequately instructed on the use of these machines, as with all
electrical equipment, care and attention must be exercised at all times during use,
you must also make certain that routine and preventative maintenance is carried out
periodically to ensure safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the
correct standard could render this equipment unsafe and the manufacturer can accept no
responsibility in this respect.
This machine is for DRY USE only
You must disconnect the machine from the mains by removing the plug from the supply
socket BEFORE cleaning or maintenance and when replacing parts or converting the
machine to another function.
This appliance is intended to be assembled, cleaned and maintained by an adult.
This machine is not suitable for the collection of biological hazards, hazardous or
explosive dusts. Contact your local distributor if you require a machine capable of
performing these tasks.
This machine is not a toy; children shall not play with this machine.
The machine must not to be used by persons with reduced physical, sensory or mental
capabilities, or lack of experience or knowledge, unless they have been given supervision
or instruction.
You must not allow the supply cord to come into contact with rotating brushes (if tted).

Do
● Keep your machine clean.
● Keep lters clean.
● Use lter bags, they will enhance performance and help keep machine clean.
● Use a Numatic original lter bag under ne dust conditions.
● Keep hoses and tubes clear.
● Replace any worn or damaged parts immediately.
● Regularly examine the power cord. If damage is found such as cracking or aging the
power cord must be replaced by a competent person using the correct Numatic original
part.
● Change dust bag frequently.
● Keep diffuser lter (where tted) clean.
● Only use the brushes provided with the machine. The use of other brushes may impair
safety.
Don’t
● Unreel the cable with one pull or pull on the cable to unplug the machine from the power
supply.
● Use to suck up hot ashes or lighted cigarette ends.
● Use steam cleaners, pressure washers or immerse in water to clean the machine.
● Attempt machine maintenance or cleaning unless the power supply plug has been
removed from the supply outlet.
● Use in a wet environment or to collect wet materials.
● Store your machine in wet conditions.
Data
NV Filter
604119 White Permatex Filter + grid
NVD Filter
604137 Red Filtrex Filter = grid
604113 White Permatex Filter
604138 Two Stage - Both Red and White Filters complete
HepaFlo Dust Bags
604019 NVM 4BH Filter(Pack of 10)
Replacement parts
Machine Cleaning
Range
Motor Weight
(Ready to work)
Sound Pressure
NV 750
NVD 750
110 Volt
32.8 m
26.8 m
32.8 m
1200W
2400W
16.8 kg
23.6 kg
66.0 dB (A)
77.1 dB (A)
Uncertainty 0.2 dB
Drum Size Protection Class Size
35L Class I 740 x 450 x 400 mm

Schematic NV 750S
Schematic NVD 750S

Declaration of conformity
EU DECLARATION
OF
CONFORMITY
We hereby declare under our sole responsibility that the
following equipment fulls all the relevant provisions of the
following EU Directives:
Machine Description: Vacuum Cleaner
Type: NV,NVD,NVQ,NVDQ series
Relevant standards upon which conformity is declared
include:
IEC 60335-1:2010
IEC 60335-2-2:2009
IEC 60335-2-69:2002 +A1:2004 +A2:2007
EN 55014-1:2001 +A1:2001, +A2:2002
EN 55014-2:1997 +A1:2001 (Cat II)
EN 50366:2003 +A1:2006
A technical construction le for this equipment is retained at
the manufacturer’s address under the authorisation of the
following signatory:
Signed: Date: 20/04/2016
Numatic International Limited,
Chard , Somerset.
TA20 2GB
www.numatic.co.uk GB
16
Position: Technical ManagerName:Allyn Boyes
Manufactured by: Numatic International Limited
Machinery Directive 2006/42/EC
EMC Directive 2014/30/EU
RoHS Directive 2011/65/EU

Warranty

Specication subject to change without prior notice
www.numatic.com © Numatic International Limited
Numatic International Limited, Chard, Somerset, TA20 2GB
Telephone: [phone]
Fax: [phone]
UNITED KINGDOM: www.numatic.co.uk GERMANY: www.numatic.de SWITZERLAND: www.numatic.ch
FRANCE: www.numatic.fr NETHERLANDS: www.numatic.nl SOUTH AFRICA: www.numatic.co.za
PORTUGAL: www.numatic.pt
903308 06/16 (A01)