AYRSTONE AyrMesh IndoorAP User manual

Check the contents
of the box:
• AyrMesh IndoorAP
• Antenna
• Mounting Bracket
• Mounting Screws
1Start Here
Ayrstone.com/support
Visit
for detailed instructions,
videos, slide shows, and a
troubleshooting guide
Quickstart Guide - AyrMesh™IndoorAP
2Assemble the IndoorAP
Pull o the rotective cover and screw the
antenna onto the IndoorAP.
Do not use tools and do not tighten
beyond #nger-tight.
NOTE: AyrMesh IndoorAP must be connected to the Power Su ly of one of our
outdoor roducts (AyrMesh Hub, Receiver, or Bridge), which must be installed
and working before you install the IndoorAP.
Mount the IndoorAP and the Power Su ly indoors where it will stay dry.
We recommend mounting the IndoorAP u high on the wall for maximum range
and bandwidth inside your building.

DO NOT FORCE CABLES IN OR OUT OF PORTS!
3Attach to
Power upply
Un lug the Ethernet cables from the
outdoor roduct's ower su ly. Insert the
IndoorAP to the “POE” side of the ower
su ly and ress until the IndoorAP
“clicks” onto the ower su ly. (NOTE:
you have to ress retty hard) Then lug
the outdoor roduct's Ethernet cable back
into the IndoorAP's PoE ort. Do not lug
anything into the IndoorAP's LAN ort
until you have con#rmed it is working.
The IndoorAP will check in to
AyrMesh.com and automatically a ear in
your account.
4Connect bracket
and mount Attach the mounting bracket to the wall
with the two included screws. Note that
there is a small bubble level on the to
of the bracket to hel level the bracket.
The Power Su ly and IndoorAP sna
into the mounting bracket by lacing the
tabs on the bottom of the IndoorAP into
the slots on the bottom of the bracket,
then rotating the IndoorAP and Power
Su ly u until they click into lace.
5Check Light
Plug the ower su ly into wall ower.
In normal use, the light on the IndoorAP should shine solid blue.
The ower su ly light will remain shining solid white.
The IndoorAP light will blink white when it is booting.
If the IndoorAP light blinks blue, it means it is disconnected from
the Internet – check the connections.
NOTE: The SSID used by the IndoorAP will be the
Hub's SSID with “_IndoorAP” a ended.