Aztech ASF883 Instructions for use

PLEASE KEEP THIS EASY START GUIDE FOR FUTURE USE.
ASF883
Aztech 16” Stand Fan
EASY START GUIDE
PACKAGE CONTENTS
ASSEMBLING THE STAND FAN
• Main Body
• Fan Blade
• Fan Stand
• Fan Base
• Front Grill
• Rear Grill
• Remote Control
• Easy Start Guide
• User Manual
• Warranty Policy
1. Attach the Outer Tube and Base Cap to the Fan
Base.
2. Using the Base Nut and Base Screw, fasten the
Fan Base tightly to the Outer Tube.
3. Loosen the Height Adjustment Ring and pull
out the Inner Tube until the desired fan height
is achieved. You may then fasten the Height
Adjustment Ring to tightly clamp the Inner Tube
with the desired height in place.
4. Ease in the Main Body into the Outer Tube and
fasten the Main Body Lock to hold it in place.
5. On the Fan Motor, position the Rear Grill with the
Fan Handle facing up. Ensure that the Rear Grill
is stably positioned into the grooves of the Fan
Motor.
6. Using the Grill Nut, fasten the Rear Grill by turning
it clockwise until the Rear Grill is securely fastened
into place.

PLEASE KEEP THIS EASY START GUIDE FOR FUTURE USE.
7. Install the Fan Blade by mounting it into the Motor
Shaft. Ensure that the Fan Blade has securely
reached the motor shaft’s retaining pins.
8. With the Fan Blade in place, t the Fan Blade Cap
into the motor shaft and turn it counter clockwise
to tightly lock in the Fan Blade into the motor shaft.
9. Attach the Front Grill by easing it properly against
the Rear Grill. Use the Fan Grill Clip, securely lock in
both grills in place.
ASSEMBLING THE STAND FAN
1. Position the fan on a smooth and stable ground
and plug its power adapter to a power outlet.
NOTE: Ensure that there are no objects within
2 meters of the fan’s head that may hinder its
oscillation / swing feature.
2. Firmly lower or raise the fan’s head angle until
you get the desired fan head angle.
3. Press the ON/SPEED button to turn ON the fan.
NOTE: By default, the speed is set to LOW. Upon
setting your preferred speed (e.g. high), and
turning it OFF and ON again, the fan would
resume using the previously selected speed (e.g.
high).
TIPS BEFORE USING THE FAN
• Before use, please check if the power voltage of the fan correctly
corresponds to your home’s power supply.
• Ensure to insert two (2) AAA batteries in the Remote Control’s battery
compartment while observing the correct polarity. If the remote control
would not be used for long periods of time, remove the remote control’s
battery.
• Should damages be found in the appliance, please do not use the
appliance and immediately bring it to the Aztech Service Center for
repair or replacement.
ADJUST
HEAD TILT
STABLE GROUND
2 METERS