BABY DELIGHT Go With Me Span Installation guide

1
Go With Me™Span
Expandable Folding Gate
Care & Instructions
Contents
Note: This gate works in openings with a width of 30” – 48”
Travel Bag
© 2019 Baby Delight, Inc. | 1-401-333-6800 | www.babydelight.com
MADE IN CHINA
Gate
Fabric cover Tension nutsTension nuts
Tension boltsTension bolts
Tension bolts Tension bolts
Metal frame
Unlocking levers
(under cover)
Tension
nuts
Tension
nuts
Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE. Prior to using the product, check
that the product and all parts were not damaged during delivery.

2
1 2 3
Remove gate from bag,
unfasten CLIP and unfold GATE
in a V shape.
Open GATE to form a square. With LOGO on the top rail,
expand GATE into doorway
opening by pulling apart left
and right FRAMES until snug
in doorway. Make sure GATE is
sitting on the floor.
Assembly/Operating
Children have died or been seriously injured when gates are
not securely installed.
• ALWAYS install and use gate as directed using all required parts.
• STOP using when a child can climb over or dislodge the gate.
• Use ONLY with the 4 locking knobs securely tightened. Check frequently
and securely tighten as necessary.
• NEVER use a gate to keep child away from pool.
• NEVER leave child unattended.
• This product will not necessarily prevent all accidents. Proper supervision
is required at all times.
• DO NOT use if any components are missing or damaged.
• Adult assembly required. Exercise care when unpacking and
assembling product.
• Use only on openings between 30” and 48” wide.
• Make sure the bottom of the gate is flat to the floor at each corner.
• DO NOT step over gate.
• Make sure the four wall pads fit securely against wall or opening.
• DO NOT use on rounded/curved surfaces.
• DO NOT use this gate at the top of stairs.
WARNING: IMPORTANT!
KEEP FOR FUTURE REFERENCE!

3
Assembly/Operating - Continued
4
6
5
NOTE: If you expand the GATE too widely,
simply place GATE on the floor upright
with logo facing sideways and press the
UNLOCKING LEVERS under the FABRIC
COVER at the same time to compress gate to
start Step 3 over.
Repeat for bottom
TENSIONING NUTS until entire
GATE is tight in the doorway.
Note: For walls without
molding, top and bottom gaps
on each side between GATE
and doorway should be equal.
Rotate top TENSION NUT on right and left
side counter-clockwise until tight in the door
opening.

4
Removing from doorway and folding for travel
1 2
Turn gate on its side with logo
on the righthand side and
press UNLOCKING LEVERS
under the FABRIC COVER on
both sides at the same time
to compress gate. Gate should
compress to a square shape.
4
Snap clip together and place in
bag for storage.
3
When in “V” Shape, fold until
the corners come together.
Rotate TENSION NUTS clockwise at each corner until GATE is loose enough to remove
from doorway
With CORNER HINGES facing you, fold opposite corners (without
HINGES) toward each other until GATE folds into a “V” shape.
NOTE: If GATE does not fold easily, re-expand gate and then
compress again making sure gate is fully compressed
(about 26” x 26”) per Step 1.

5
Care & Cleaning
Limited Warranty
Caring for your new GoWithMe™Span Expandable Folding Gate is very easy.
• Regularly check TENSION BOLTS to make sure the GATE is securely in place.
• Do not use the GATE if any components are damaged or missing.
• Surface-clean with a damp cloth or sponge, using mild detergent and
warm water.
At Baby Delight, Inc. we make innovative and high quality products for babies,
children and their parents. We warrant this product to be free from defects in
material and workmanship existing at the time of manufacture for a period of
90-days from the date of initial purchase (sales receipt is required for proof of
purchase). If such a defect is discovered during the limited warranty period, we
will, at our sole option, repair or replace your product at no cost to you.
This limited warranty does not cover claims resulting from misuse, failure to
follow the instructions on installation, maintenance and use, abuse, alteration,
involvement in an accident, and normal wear and tear.
For warranty service or replacement part information:
USA: Please call 1-401-333-6800, email [e-mail], or write to
Consumer Services: 30 Martin Street, Suite 3C, Cumberland, RI 02864
Some replacement parts may be available for purchase after this limited warranty
expires. Please visit us at www.babydelight.com or call us at 1-401-333-6800
or details.
www.babydelight.com
© 2019 Baby Delight, Inc. | 30 Martin Street, Suite 3C, Cumberland, RI, 02864, USA
1-401-333-6800 | [e-mail]
Patent Pending | BD05410