BABY DELIGHT Alpine Wave BD06090 Installation guide

1
Care & Instructions
©2021 Baby Delight, Inc. 1-401-333-6800 www.babydelight.com
BD06090 | MADE IN CHINA
Contents
Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE. Do not use this product if it is
damaged or broken. Use from birth until baby starts trying to sit up or
has reached 20 lb (9 kg), whichever comes rst.
Remote ControlFabric CoverNewborn Insert
Toy Bar
A/C Adapter
Driftwood
fashion
2-position
recline
Removable,
washable cover
A/C adapter
(included) or
4 “AA” batteries
(not included)
Detachable
toy bar with
two soft toys Breathable
newborn insert
Tool-free
assembly
5-speed, remote
control motion,
sounds and auto timer
Scan Code for
more product
information
Left and Right
Back Legs
Motion Unit/
Lower Frame
Left and Right
Upper Frame
3-point
safety harness
Deluxe Bouncer with Motion
Alpine Wave

2
BOUNCER MODE: (without motion activated)
FALL Hazard: Babies have suered skull fractures falling while in and from bouncers.
• Use bouncer ONLY on oor.
• NEVER lift or carry baby in bouncer.
SUFFOCATION HAZARD:
• Babies have suocated when bouncers tipped over on soft surfaces
and/or when bouncers have been used as a sleep product.
• NEVER use on a bed, sofa, cushion, or other soft surface. Stay near and watch baby during use.
To prevent falls and suocation:
• ALWAYS use restraints and adjust to t snugly.
• STOP using bouncer when baby starts trying to sit up or has reached 20 lbs., whichever comes rst.
To prevent injury
• NEVER adjust recline position while baby is in bouncer.
• ALWAYS check that recline adjustment is locked BEFORE each use.
• ALWAYS use the newborn insert until the child is at least 4 months of age and can hold head
upright unassisted.
This product is not safe for sleep or unsupervised use. If baby falls asleep, move baby as soon as
possible to a rm, at sleep surface such as a crib or bassinet.
SWING MODE: (motion activated)
FALL and STRANGULATION HAZARDS: Infants have suered head injuries falling from swings and
strangled in straps.
• ALWAYS use restraints and adjust to t snugly.
• STOP using product when infant attempts to climb out (approximately 6 months).
• ALWAYS stay near and watch infant during use. This product is not safe for sleep or unsupervised
use. If baby falls asleep, move baby as soon as possible to a rm, at sleep surface such as a crib
or bassinet.
• ALWAYS place swing on oor. Never use on any elevated surface.
SUFFOCATION HAZARD: Young infants have limited head and neck control. If the seat is too upright,
infants head can drop forward and compress the airway.
• ALWAYS keep swing fully reclined and use newborn insert until infant is at least 4 months old and
can hold up head without help.
WARNING:
FAILURE TO FOLLOW THESE WARNINGS AND THE IN-
STRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. DO NOT USE THIS PRODUCT
IF YOU CANNOT EXACTLY FOLLOW THE INSTRUCTIONS THAT COME WITH IT.
Warning—Strangulation Hazard—Children have STRANGLED in cords.
Keep the AC Adapter cord out of the reach of children (more than 3 ft (0.9 m) away).
Safety Precautions

3
2
Plug UPPER FRAME into LOWER
FRAME with holes facing inward until
you hear a “click”.
Attach the two BLACK ELASTIC LOOP
on inside, bottom of FABRIC COVER
to the FRAME.
Unfold BOUNCER upright.
With non-skid feet facing down, plug
the LEFT and RIGHT BACK LEGS into
the LOWER FRAME LEGS by pressing
BUTTONS until you hear a click.
Slide the FABRIC COVER
over the FRAME.
Plug the LEFT and RIGHT UPPER
FRAME pieces into each other
by pressing BUTTON until you
hear a “click”.
1
3
5 6
4
2
Assembling the Bouncer

4
Assembling the Bouncer (Continued)
Unbuckle CHILD RESTRAINT STRAPS
and place child in BOUNCER.
Make sure the FRAME is securely locked
into the RECLINE ADJUSTER by pressing
down RECLINE LOCK LEVER. You should
hear an audible “click”.
NOTE: Make sure the RECLINE AJUSTER is locked into the desired recline spot.
The Bouncer has 3 positions; 2 position
recline and 1 position folded (see pg.9).
For recline, click the FRAME BACKREST
into either of the two positions of the
RECLINE ADJUSTER by adjusting the
FRAME and pressing down RECLINE
LOCK LEVER.
10
Buckle child into CHILD RESTRAINT
and tighten STRAPS for a snug
and secure fit.
Attach the TOY BAR to the FRAME by
pressing CLIPS on to the FRAME.
11
9
7 8

5
Assembling the Bouncer (Continued)
This BOUNCER may be used with or without the NEWBORN INSERT based
on the size and comfort of your child.
To use the NEWBORN INSERT, insert CHILD RESTRAINT STRAPS through
SLOTS in the NEWBORN INSERT and pull the CHILD RESTRAINT through
the lower section of the NEWBORN INSERT.
12
13

6
3 4
If using batteries, unscrew BATTERY DOOR with Phillips Head screw driver
(not included) on back of CONTROL UNIT.
Insert 4 “AA” batteries (not included) in accordance with the +/- polarity shown inside
BATTERY COMPARTMENT and replace BATTERY DOOR with screw.
Control Unit Function
1 2
This product can be powered by AC
ADAPTER (included) or four 1.5V AA
batteries (not included).
Plug AC ADAPTER JACK into the
CONNECTOR on the rear left hand
side of the CONTROL UNIT and plug
into a wall socket from the back of the
CONTROL UNIT. Use the fabric hook and
loop fastener to secure the cord to
the FRAME LEGS and keep AC ADPATER
CORD away from child.
Battery Warnings:
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries.
Remove batteries before putting bouncer into storage for a prolonged
period of time.
CAUTION
To prevent battery leaks, which can burn skin and eyes:
• Always replace the entire set of batteries at one time.
• Never mix old and new batteries, or batteries of dierent brands or types.
• Remove batteries when storing product for a long time.
• Dispose of used batteries immediately.

7
Control Unit Function
POWER ON/OFF: Press to turn on and o power. Red LED will light when
on. NOTE: Turning unit on or o is only possible on CONTROL UNIT, not on
the REMOTE CONTROL.
POWER ON/OFF
POWER INDICATOR LIGHT
MOTION INDICATOR LIGHT
TIMER INDICATOR LIGHT
(3 LIGHTS)
MOTION ON/OFF
TIMER
MOTION SPEED DOWN
MUSIC PLAY/PAUSE
MOTION SPEED LEVEL
(5 INDICATOR LIGHTS)
REMOTE CONTROL
RECEIVER
MUSIC SELECTION/
VOLUME
MOTION SPEED UP
MUSIC PLAY/PAUSE: Press the button once to start playing music. Press it
second time to stop playing music.
MUSIC SELECTION/VOLUME: Press to scroll through the music/sounds.
HOLD BUTTON DOWN TO ADJUST THE VOLUME once music is selected.
MOTION SPEED: There are five motion speeds. Press “+” to increase speed
and “-” to decrease speed. LEDs will indicate which of 5 speeds is selected.
NOTE: Motion is restricted when MOTION LOCK is in the UP position. Avoid
turning motion on when the MOTION LOCK in engaged.
MOTION ON/OFF: Press to turn motion on or o. Orange LED will light
when on. (Automatically will start to the lowest motion speed.)
TIMER: There are three timer settings. Press once to illuminate the LED for
8 minutes, twice for 15 minutes, and a third time for 15 minutes, and a third
time for 30 minutes. All functions will turn o after chosen time. If a time is
not selected, all functions will remain on until CONTROL unit is powered o.

8
MOVE
8
15
30
Remote Control Function
Remove battery pull tab (3V CR2025 lithium coin battery is included)
from bottom of remote control before first use.
NOTE: To turn power on or o, please press the POWER BUTTON
on the CONTROL UNIT on BOUNCER.
MUSIC PLAY/PAUSE: Press the button once to start playing music.
Press it second time to stop playing music.
MUSIC NEXT SOUND: Press to scroll through the music/sounds.
MUSIC LAST SOUND: Press to scroll back through the music/sounds.
VOLUME UP: Press to increase the volume.
VOLUME DOWN: Press to decrease the volume.
MOTION SPEED UP: Press to increase the motion.
MOTION SPEED DOWN: Press to decrease the motion.
MOVE: Press to turn motion on or OFF.
TIMER: There are three timer settings. Press once to illuminate the
LED for 8 minute timer, twice for 15 minutes, and a third time for 15
minutes, and a third time for 30 minutes. All functions will turn o
after chosen time. If a time is not selected, all functions will remain
on until CONTROL unit is powered o.
8
15
30
MOVE
MOVE
VOLUME UP
MOTION SPEED UP
MOTION SPEED UP
MOTION SPEED DOWN
PULL TAB
MUSIC LAST SONGMUSIC PLAY/PAUSE
TIMER
VOLUME DOWN

9
Folding the Bouncer
1
3
2
Remove the TOY BAR by pulling
the TOY BAR o with both hands in
a downward direction.
While pressing the SILVER LEVER, lift RECLINE LOCK LEVER
up until FRAME folds flat.
Press the SILVER LEVER in on back
of CONTROL UNIT.

10
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
WARNING! Changes or modications to this unit not expressly
approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected. Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.