10
FRAME
1 Unpack the stroller frame from the box
and set the wheels aside.
Unlock the stroller by pullin the
Storae Lock Lever.
2 Lift the Handlebar away from the lower
frame. The stroller will click into place.
3 Place the stroller in the upriht position.
WARNING: Ensure that all the lockin
devices are enaed before use.
FRONT WHEEL
4 Installation
• Lay stroller on its back so the
Handlebar is restin on the floor.
• Attach the Front Wheel by slidin it
into the front wheel mount until it
clicks. Gently pull on the Front Wheel
to make sure it is properly attached.
5 Removal
• While pressin the front wheel release
button, ently slide the Front Wheel
out of the front wheel mount.
SWIVEL FEATURE
6 Press the Swivel Lock button down
and slide the Swivel Lock to the left to
lock the front wheel assembly in a fixed
position for lon distance strollin.
7 Press the Swivel Lock button down
and slide the Swivel Lock to the riht
to allow the front wheel assembly to
swivel.
WARNING: When loadin and
unloadin child, lock the front wheel in
a fixed position. Althouh the
front wheel of your stroller locks, it is
not intended for join or exercise
purposes.
REAR WHEELS
8 Installation
• Alin the Rear Wheel axle with the
wheel mount on the stroller frame
and insert it into the wheel mount
until it clicks into place.
• Gently pull on the Rear Wheel to
make sure it is properly attached.
9 Removal
• While pressin the Wheel Release
Button, ently slide the Rear Wheel
out of the wheel mount.
BRAKE
10 To Lock the Brakes: ently pull the
Brake Lever into upriht position until it
clicks into place.
11 To Release the Brakes: Pinch the ray
tabs and pull the lever towards you.
Push the Brake Lever down until it is
parallel with the frame.
WARNING: Lock the brakes before
loadin and unloadin your child and
whenever the stroller is not movin.
SEAT - UNFOLD THE SEAT
12 Holdin the footwell and the top of the
seat, open the seat.
13 The seat will lock into its open position.
CANOPY
14 Attach the canopy to the frame: Attach
the Canopy’s brackets to the sides of
the seat frame.
15 Attach the 3 fastenin strips on the
canopy to the top of the seat.
ADJUSTING SAFETY HARNESS
16 From the back of the seat, undo the
fastenin strip and open the pocket to
locate the plastic square stopper. Turn
stopper and pass throuh the openins
in the PE board and seat fabric.
17 Reinsert stopper at seat openin closest
to child’s shoulders. Pass back throuh
seat fabric and PE board. Tu on strap
to ensure stopper is locked. Repeat on
both sides.
WARNING: Avoid serious injury from
fallin or slidin out. Always properly
adjust and fasten safety harness.
WARNING: Always use the crotch strap
in combination with the shoulder straps
and waist belt.
18 Slide the Harness Pads up to access
plastic uide on strap.
19 Hold the plastic uide and pull strap to
tihten or loosen.
EN