Baby Trend Type 1 User manual

Convenience through innovation and thoughtful design
Instruction Manual
Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.
11.07
www.babytrend.com
Type 1: without Toy Basket
Type 2: with Toy Basket

WARNING
1Copyright © 2007 - 2008, Baby Trend Inc., All Rights Reserved.
WARNING: Failure to follow these warnings and the
instructions could result in serious injury or death.
WARNING: The tray is not designed to hold the child in the
chair. The child must be secured by the safety harness at all times
while in the high chair.
WARNING: Prevent serious injury or death from falls
or sliding out. Always secure child in the 5-point harness system
either in the reclining, semi-reclining or upright position. The tray
is not designed to hold the child in the chair. Always keep child
in view while in high chair. Never leave child unattended. It is
recommended that the high chair be used in the upright position
only by children capable of sitting upright unassisted. See page 5
for instructions on proper use of restraint system.
• Accessory items may change the balance of the high chair and cause
hazardous unstable conditions.
• Be certain the high chair is fully erect and latched in the open position
before allowing the child near the high chair.
• Use of the high chair with a child weighing more than 45 pounds will
cause excessive wear and stress on high chair.
• NEVER allow your high chair to be used as a toy.
• NEVER use this product if there are any loose or missing fasteners, loose
joints, broken parts, or torn mesh/fabric. Check before assembly and
periodically during use. Contact Baby Trend Customer Service at
1-800-328-7363 for replacement parts, repair or instructions.
NEVER substitue parts.
MAINTENANCE AND CLEANING INSTRUCTIONS:
Use only household mild soap and warm water.
NO BLEACH. DO NOT MACHINE WASH.

Copyright © 2007 - 2008, Baby Trend Inc., All Rights Reserved. 2
Contact us by phone:
1-800-328-7363 (8:00am ~ 4:30pm PST)
or online http://www.babytrend.com
Contact us by mail:
Baby Trend, Inc.
1567 S. Campus Ave., Ontario, CA 91761
PARTS
Seat
Tray
Caster (4) Dishwasher safe food tray
If you experience any difculty with the use of our product or have a question regarding
these instructions, please contact our Customer Service Department at 1-800-328-7363
between the hours of 8:00 a.m. and 4:30 p.m. (PST). Please do not return the product
to the store as once it is returned it cannot be re-sold and the materials and energy used
to make it are wasted.

Copyright © 2007 - 2008, Baby Trend Inc., All Rights Reserved.
ASSEMBLY
IMPORTANT! To ensure safe operation of your product,
please follow these instructions carefully. Please keep these
instructions for future reference.
IMPORTANT! Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or sharp
edges. NEVER use if any parts are mssing or broken.
IMPORTANT! Adult assembly is required.
IMPORTANT! Always check that the high chair is locked
in the open position before using.
ATTENTION:
Carefully remove high chair from box. The high
chair is shipped fully assembled except for the
casters and tray.
TO ASSEMBLE FRAME
Depress the fold release buttons located on the
top of the frame and push the legs apart until fully
open and locked. (Fig. 1)
TO ASSEMBLE WHEELS
1. To attach the wheels, gently lay frame on its
side.
2. Insert wheel into bottom of frame. Apply
pressure and push the wheel all the way in until
wheel secured. (see Fig. 2)
Repeat for the remaining wheels.
Fold Release
button
Push
Fig. 1
Fig. 2
3

Copyright © 2007 - 2008, Baby Trend Inc., All Rights Reserved. 4
TO ATTACH AND
OPERATE TRAY
To attach the tray, line up the grooves on the
bottom of the tray with the armrests of the high
chair. Squeeze the tray release handle (Fig. 3)
and slide the tray onto the armrest (Fig.4). The
tray has a 3-position adjustment.
To adjust the position, squeeze the tray release
handle located underneath the tray and reposition
the tray to the desired position. (Fig.5). Release
tray release handle. Check that the tray is
securely locked in it’s new position.
The dishwasher safe food tray snaps onto the
high chair tray and is held in place by tabs on
either side of the tray. When installing the food
tray make sure that it snaps into place to prevent
the child from removing the food tray. To
remove the food tray, carefully lift outward on
the tabs on each side.
ASSEMBLY
Fig. 3
Fig. 4
Fig. 5
Tray Release
Handle

Copyright © 2007 - 2008, Baby Trend Inc., All Rights Reserved.
SAFETY
RECLINE SEAT
Squeeze recline lever on back of the seat and
adjust to the preferred recline or upright position.
(Fig.6)
SAFETY BELT
1. Place your child’s arms through the loops
formed by the shoulder and waist straps.
Place the crotch strap between your child’s
legs. Insert the harness buckles into the center
buckle to fasten.
2. Adjust shoulder and waist straps for your
child’s comfort and safety by sliding buckles
in either direction. Safety straps are to t snug
around your child. (see Fig. 7)
WARNING: Failure to follow these warnings and the
instructions could result in serious injury or death.
WARNING: It is recommended that only children capable of
sitting upright unassisted use the high chair in the upright position.
WARNING: Prevent serious injury or death from falls or
sliding out. Always secure child in the restraint system, either in
the reclining, semi-reclining or upright position.
WARNING: Do not adjust seat height with child in seat.
Adjust seat height before placing your child in the high chair.
WARNING: Always check that the height adjustment
bracket is level and both left and right sides locked before placing
child in the high chair.
5
4 Positions
Recline Lever
Fig. 6
Fig. 7
Adjust for a
snug t
Adjust for a
snug t

Copyright © 2007 - 2008, Baby Trend Inc., All Rights Reserved. 6
Fig. 8
3. To release, squeeze the buckles to unfasten.
(Fig. 8)
ADJUST SEAT HEIGHT
Squeeze the levers on the height adjustment
bracket and adjust to the ideal position. (Fig. 9)
TO FOLD HIGH CHAIR
The high chair may be folded with the seat in any
of the height positions. The high chair will be the
most compact with the seat in the lowest position,
though the tray will only hang with the seat in the
highest position.
1. Place seat in the desired height position
(Fig. 9).
2. Place seat back in the most upright position.
3. Squeeze the tray release handle and slide the
tray out. (Fig. 10)
4. Hang the tray (Fig. 11a) on the hooks located
on the back of the rear leg. (Fig. 11b)
Fig. 9
6 Positions
Height adjustment
bracket
SAFETY
Fig. 10
Fig. 11a
Cut out
for Hook
Cut out
for Hook
Hooks
Fig. 11b

Copyright © 2007 - 2008, Baby Trend Inc., All Rights Reserved.
SAFETY
5. Fold up the footrest. (Fig. 12)
6. Depress in the release buttons (located on the
sides of the frame) and push the front legs in
the direction of the rear legs until locked.
( Fig. 13) Chair is now ready to put away.
MAINTENANCE AND CLEANING
INSTRUCTIONS:
Dishwasher safe food tray:
The food tray is dishwasher safe to 160º degrees
Fahrenheit. DO NOT USE SCOURING PADS
on the Dishwasher food tray as they will damage
the surface and the tray will become more difcult
to clean.
High Chair/Tray:
Clean high chair after each use using mild
household detergents. Please use only a soft bristle
brush, sponge or cloth to surface clean or remove
particles of food. DO NOT submerge high chair
tray in water: Surface clean only.
To remove pad for washing:
Unsnap the shoulder straps from the waist belt
buckle and push through hole in pad. Push waist
belt buckles and crotch strap through holes in pad.
Gently pull upward on pad to remove. Wash pad
with warm water, soap and a sponge for light stains.
For a complete wash DRY CLEAN ONLY. DO
NOT MACHINE WASH OR DRY SEAT PAD.
DO NOT USE BLEACH. Hang to dry. Replace
pad and rethread safety harness in reverse order.
From time to time check your high chair for loose
screws, worn parts, torn material or stitching.
Replace or repair the parts as needed.
Excessive exposure to the sun or heat could cause
fading, yellowing or warping of parts.
Fig. 12
Fig. 13
7