Babyhug BGBW007 User manual

STYLE CODE : BGBW007
1) Inspection and adjustment must be done before using the walker.
2) The height of the cushion should be properly adjusted to avoid the babies falling out.
3) Make sure all the locking devices are in the locked state before use.
4) Avoid using baby walker on or near threshold, stairs or irregular places; it may result in serious injury.
5) Do not use baby walker on a slope driveway or street.
6) Do not allow other child to push the baby walker when there is baby in it.
7) Do not use the baby walker when the baby can walk independently.
8) Never leave your baby unattended when in use.
Warning
1) To avoid accidental injury, inspect the baby walker on regular basis.
2) Please check all the parts for any damage or rupture and change them if required before using the walker.
3) Seat cloth is hand washable. Babyhug laundry detergent is recommended.
4) This walker contains small part for assembly purpose, please store them carefully and keep away from baby.
5) Do not use or store the baby walker at irregular, damp, cold or high-temperature places for a long time.
Maintenance
baby walker
Carrying Capacity
UP TO 15 Kgs
AGE GROUP
6 MONTHS +
baby walker
Stepping with Joy
Parental bar Stopper 4 Levels of height adjustment
First Walk Musical Baby Walker

Unfold
Fix the base and pull the panel up to the
needed height level, make sure the safety
device is in locked state.
Assembly Instructions
Install Wheels
Install the wheels in the chassis by hands. It
doesn't required any auxiliary tools for fitting.
Seat
Musical Toy Tray
Wheels
Stopper
Chassis
Push bar
Height adjustment bar
Panel
Know Your Product Well
Install the Battery Music
Insert the toys into the holes of the plate. Open the
battery lid on the music box, put two 1.5V batteries
inside, close the battery lid, tighten with screw. _+
+_
AA 1.5 V
AA 1.5 V
Install Stopper
As shown in picture, insert the stopper into the
plastic holes in chassis and tighten it with 4 pieces
of 4 mm screws. When in use, rotate 90º towards
right and when not in use rotate 90º degree
towards left.
Stopper
Adjust the Height
As shown in picture, fix the base then press down or
pull up the panel to the needed height, make sure
the safety device is in the locked state.
Adjust the Panel
As shown in picture, press the left and right side
button on the panel, move the panel front and
rear to adjust the space.
Install Seat Cushion
Insert the plastic bolts into the holes around the
panel. Put the plastic stick through the seat cloth's
hole and then tighten with screws.
Install the Parent Push Bar
Insert the bar into the hole located at
the backside of the walker.
Install the Toys
Insert the toys into the holes of the toy tray.