Babyhug BGBW009 User manual

Maintenance
1) To avoid accidental injury, inspect the baby walker on regular basis.
2) Please check all the parts for any damage or rupture and change them if required before using the walker
3) Seat cloth is hand washable. Babyhug laundry detergent is recommended.
4) This walker contains small part for assembly purpose, please store them carefully and keep away from baby.
5) Do not use or store the baby walker at irregular, damp, cold or high-temperature places for a long time.
1) Inspection and adjustment must be done before using the walker.
2) The height of the cushion should be properly adjusted to avoid the babies falling out.
3) Make sure all the locking devices are in the locked state before use.
4) Avoid using baby walker on or near threshold, stairs or irregular places; it may result in serious injury.
5) Do not use baby walker on a slope driveway or street.
6) Do not allow other child to push the baby walker when there is baby in it.
7) Do not use the baby walker when the baby can walk independently.
8) Never leave your baby unattended when in use.
Warning
STYLE CODE : BGBW009
baby walker
Carrying Capacity
UP TO 15 Kgs
AGE GROUP
7 to 15 MONTHS
baby walker
Stepping with Joy
Removable Seat 4 Levels of Height Adjustment Engaging Toys
Little Explorer Walker Cum Rocker

Know Your Product Well
Seat
Wheels
Height adjustment bar
Chassis
Panel
Musical Toy Tray
Push bar
Assembly Instructions
Unfold
Fix the base and pull the panel up to the
needed height level, make sure the safety
device is in locked state.
Install Wheels
Install the wheels in the chassis by hands. It
doesn't required any auxiliary tools for tting.
Adjust the Height
As shown in picture, x the base then press down
or pull up the panel to the needed height, make
sure the safety device is in the locked state.
Install Seat Cushion
Insert the plastic bolts into the holes around
the panel. Put the plastic stick through the
seat clothes hole and then tighten it with
screws.
Install the Battery Music
Install two batteries, press any one of the key for
music. For changing the batteries, open the cover
of battery box, take out the used battery and put in
the new ones. Then put the cover back and lock it
with the screw.
Panel Adjustment
Reconstruction in Rocking Base
When using rocking function
Turn the white knob to open state. Press two red buttons on
one side of the chassis and then turn the chassis in inward
direction. Same procedure applies for the other side.
Install the Parent Push Bar
Insert the bar into the hole located
at the backside of the walker.