edge of the area you wish to outline.
• Having dened the outline, hold the trimmer with the blades pointing
upwards against the direction of hair growth. This will trim the
unwanted hair adjacent to the outline.
• Switch the Super Beard on by pressing the ‘‘I/O’’ button. The LED will
illuminate and the blades will start to move.
• If you are looking for an ultra-close nish, you can use the trimmer
without the comb guide. This will give you an extremely short cut.
IMPORTANT: Please note when using the trimmer without the comb
guide, the cutting length will be below 1mm. The length setting shown
on the LED screen will no longer be relevant when the comb guide is
detached.
Super Beard Top Tips
• Use on clean, dry hair.
• If possible, when using for the rst time, try and grow your facial hair
for a few days before cutting. This will give you a better result, as
your facial hair will feel thicker.
• Set the cutting length as required.
• It is always best to start cutting with a longer length rst, then trim
again if the length is longer than desired.
• Hold the Super Beard against the hair, the teeth of the comb guide
should be pointing upwards and should be at against the face.
• Move the trimmer upwards through the hair, a little at a time, against
the direction of hair growth.
• The Super Beard will work most effectively when cutting through
the hair at its own speed – never force through the hair. You may
experience a little resistance when trimming the neck area, where hair
is thicker and grows in many different directions. This is completely
normal.
• Just like shaving, extra time should be given when trimming under
the neck area, as again this is where hairs grow in many different
directions.
• Never switch the trimmer off whilst in the hair.
