BadgePass BP 1501 User manual

Access Control Panels
Quick Reference Guide and
Wiring Diagrams
www.BadgePass.com

BP 1501 Quick Reference Guide
All DIP switches should be set to the OFF position for normal operation.
Make sure to remove the plastic between the battery and the connector.
To set the address on the BP 1501:
•Open a browser window and go to http://192.168.0.251 (this is the default factory address for
the panel).
•Click “Login” The user name is admin and the password is password. (This can be changed once you log
in).
•Click on Network from the menu on the left.
oSet your IP address and other network information then click ‘ACCEPT’.

•Click on Apply settings in the left menu then click on the ‘APPLY SETTINGS AND REBOOT’ button. The
panel will reset.

BP 1502 Quick Reference Guide
All DIP switches should be set to the OFF position.
Make sure to remove the plastic between the battery and the connector.

To set the address on the BP 1502:
•Open a browser window and go to http://192.168.0.251 (this is the default factory address for
the panel).
•Click “Login” The user name is admin and the password is password. (This can be changed once you log
in).
•Click on Network from the menu on the left.
oSet your IP address and other network information then click ‘ACCEPT’.
•Click on Apply settings in the left menu then click on the ‘APPLY SETTINGS AND REBOOT’ button. The
panel will reset.

BP 2500 Quick Reference Guide
All DIP switches should be set to the OFF position for normal operation.
Make sure to remove the plastic between the battery and the connector.
To set the address on the BP 2500:
•Open a browser window and go to panel).

•Click “Login” The user name is admin and the password is password. (This can be changed once you log
in).
•Click on Network from the menu on the left.
oSet your IP address and other network information then click ‘ACCEPT’.
•Click on Apply settings in the left menu then click on the ‘APPLY SETTINGS AND REBOOT’ button. The
panel will reset.

BP 52 Quick Reference Guide
Make sure that only one BP 52 (If there is more than one hooked to a controller) has the RS 485
terminator (J5) jumper in place.

BP 51e Quick Reference Guide
All DIP switches should be set to off for normal operation.

Panel Wiring
Diagrams