Badger Basket Round Doll Crib 01905 Installation guide

1.0/0705
MODEL #: 01905
NAME: Round Doll Crib
TOOLS NEEDED: Phillips Screwdriver, Hammer
PARTS INCLUDED:
(A) 1 - Top Ring
(B) 4 - Leg Posts
(C) 4 - Long Screws (not shown)
(D) 15 - Dowels*
(E) 8 - Short Screws (not shown)
(F) 1 - Bottom Ring
(G) 4 - Caster Wheels
(H) 1 - Canopy Pole with Curve/Bend
(I) 1 - Metal Canopy Frame
(J) 1 - Fabric Skirt
(K) 1 - Fabric Sheet
(L) 1 - Mattress Pad
(M) 1 - Fabric Canopy
* IMPORTANT: 4 of the dowels have holes in both ends,
11 have no holes or a small hole in only one end
ASSEMBLY INSTRUCTIONS
Adult Assembly Required.
Save these instructions for future use.
This item is a toy for dolls only.
For children ages three (3) years and older.
Visit us online at www.badgerbasket.com
Toll-Free Customer Service: 1-800-236-1310 (Monday through Thursday 7:30 AM to 4:30 PM CST)
[email protected]
PLANT AND GENERAL OFFICE: PO Box 227, Edgar, WI 54426-0227 715-352-2311 Fax: [phone]
CORPORATE OFFICE: 111 Lions Dr., Suite 220, Barrington, IL 60010
Page 1 of 3
B
I
G
H
J
K
M
L
A
F
D
BEFORE
YOU
BEGIN
ASSEMBLY:
Ensure that all
the parts and
hardware listed above are
included. If anything is
missing, please do not return
the product to the store. Call
or e-mail us for assistance.

1.0/0705Page 2 of 3
PICTURE 3
PICTURE 2
STEP 1: See PICTURE 1. Attach the FOUR LEG
POSTS (B) to their designated spots on the TOP RING
(A) using the FOUR LONG SCREWS (C).
Attach the FOUR DOWELS WITH TWO HOLES (D)
using FOUR SHORT SCREWS (E). The positions of
these four dowels may vary from shown in Picture 1.
STEP 2: See PICTURE 2. Turn the crib upside down.
Insert the FOUR LEG POSTS (B) through the large
holes on the BOTTOM RING (F) and slide the bottom
ring down until it rests on the DOWELS WITH TWO
HOLES (D).
Be sure screw and dowel holes on the bottom ring are
in the right place, and the white side of the bottom
platform is facing down (white side will face up when
the crib is in the upright position).
Starting at any dowel, work your way around the ring
and alternately screw down the FOUR DOWELS
WITH TWO HOLES (D) using FOUR SHORT
SCREWS (E) and insert the remaining ELEVEN
DOWELS (D) sandwiched between the top and bottom
rings.
There is one hole for the canopy pole that you will
leave open.
STEP 3: See PICTURE 3. Turn the crib right side up.
Insert the FOUR CASTER WHEELS (G) into the
holes on the bottom of the LEG POSTS (B). Grasp
each leg and gently but firmly press each wheel against
the floor to snap it into place.
F
G
G
G
G
PICTURE 1
AB
BB
B
D
D
D
D

1.0/0705
STEP4: See PICTURES 4A and 4B. Insert the CANOPY POLE (H) through the hole on the TOP RING (A) and push it
down until it rests in the hole on the BOTTOM RING (F). Insert the two free ends of the METAL CANOPY FRAME (I)
into the top of the CANOPY POLE (H). You may need to gently tap on the canopy frame with a hammer so that the ends
are pushed down into the pole as far as possible (see PICTURE 4B).
Starting by the canopy pole, wrap the FABRIC SKIRT (J) around the BOTTOM RING (F) pressing the grip tape together.
When you get back to where you started, press the grip tape on the two ends of the skirt together. Put the FABRIC SHEET
(K) on the MATTRESS PAD (L) and place the sheet and pad into the crib.
STEP5: See PICTURE 5. Position the FABRIC CANOPY (M) over the METAL CANOPY FRAME (I). Secure the grip
tape tabs on the fabric canopy around the metal frame.Adjust the canopy so it drapes around the crib.
Your ROUND DOLLCRIB is now ready to enjoy! This beautiful item is suitable
for children from three years old and up. Please make sure children know that this
furniture is for dolls and stuffed animals only. It is NEVER to be used with real
infants or with pets. Children should NEVER attempt to sit orstand on the crib.
Page 3 of 3
PICTURE 4A
H
I
PICTURE 4B
J
K, L
PICTURE 5
M
Care instructions: Wipe crib parts and vinyl pad clean with a damp cloth
and mild detergent as needed. Fabric is poly/cotton. For longevity of the product we
recommendhandwashingthe bedding;however itcan bemachine washedon gentle
and air dried or tumble dried on low or no heat. Iron on the
lowestsetting forpoly/cotton.
H
I