Wipe Disinfection
Use a wipe Sodium Hypochlorite Disinfectant using no more that 1000 parts per million
of Active Chloride
Wooden parts may not get into contact with the relevant cleaning agent.
The use of solvents is not permitted.
Do not use abrasive cleaners, scouring pads or similar cleaning aids.
Do not use organic solvents such as halogenated/aromatic hydrocarbons and ketone
Please follow these instructions when using cleaning agents and/or disinfectants:
- Decontamination solutions in the prescribed concentrations may not exceed or fall
below a pH-value of 6-8.
- They may not contain any corrosive or caustic substances.
- They may not contain substances that alter the characteristics of the surface or the
properties of plastic or synthetic materials.
- They may not affect the properties of the lubricants.
- Water hardness may not exceed 0.9 mmol/l (to 5°d).
(Fully desalinated water may not be used)
We accept no liability for possible damage to surfaces arising from the use of unsuitable
cleaning agents or disinfectants, from the use of incorrect concentrations or from the
unsatisfactory care of the bed.
Risk of electric shock, fire or breakdown
Only clean and disinfect the bed after it has been switched off, i.e. when it has been
disconnected from the mains power supply (pull plug out of socket).
Protect electrical components from water!
Spray wands
Cleaning and disinfection with spray wands is prohibited.
The beds are not designed to be used with jet stream plants!
The Klearside Cleaning & Disinfection
Page 7
BaKare Beds The Klearside Manual Last updated Jan 2010 © BaKare Beds 2010 Issue 06
BaKare beds makes every effort to ensure that this document is up to date but does
reserve the right to make changes to its products without prior notice.
For the latest information please contact us.
