Baratza SETTE 30 Installation and user guide

How to: Cone Burr Shim Installation
Sette 30, Sette 270, Sette 270W, Sette 270Wi
Time: 10 min
Difculty: Easy
Tools/supplies: 5mm hex key (included in grinder shim kit S902)
Parts: Sette Cone Burr Shim (SKU: S904) (included in grinder shim kit)
Additional Resources: n/a
*** Unplug the grinder from power supply ***
www.baratza.com [e-mail] rev. 5/23/2019
ver. 1.0
Close the hopper gate and clear ground coffee from the system
We advise only installing one shim at a time to avoid clogs or potential damage.
One shim shifts the grind range ner by approximately 6 macro steps.
For example, if using 1F before adding a shim, start at 7F after adding a shim.
2mm Hex Sette Cone Burr Shim (SKU: S904)

www.baratza.com [e-mail] rev. 5/23/2019
Pg. 2
On separation,
the adjustment
subassembly will
snap free
Rotate the macro
adjustment assembly
in the coarse direction,
past 31 until it stops and
can be pulled down for
removal.
Place the assembly
on a work surface.
Press down evenly on
the metal adjustment
assembly to remove the
cone burr subassembly.
Pull to remove the
nozzle.
Swing portalter
hook to either side

www.baratza.com [e-mail] rev. 5/23/2019
Pg. 3
Remove the cone burr
hex bolt.
Remove the cone burr.
Add 1 shim.
Install the cone burr.
Note that the burr and
holder are keyed.
Install the cone burr hex
bolt and tighten.
Bolts must
insert into burr
Tighten fully

www.baratza.com [e-mail] rev. 5/23/2019
Pg. 4
Install the nozzle.
Place the cone burr
subassembly upside
down on the work
surface. Position the
adjustment ring and
press down evenly to
snap the parts together
into one assembly.
Insert the cone burr
holder halfway up into
the grinder. Rotate the
assembly as needed until
the cone burr holder is
keyed into the unit.
The parts will make an
audible snap sound.

www.baratza.com [e-mail] rev. 5/23/2019
Pg. 5
Line up the blue tab on
the adjustment ring with
the blue arrow on the
case.
Press up on the
assembly and rotate the
blue tab towards the rear
of the grinder.
Install the hopper
and return the unit to
operation.
If you have questions,
or encounter any issues
with this guide, contact
suppor[email protected]
Blue to blue