Bassett BP-CLFEX User manual

IF PARTS ARE MISSING OR DAMAGED, DO NOT RETURN TO STORE
To order missing or replacement parts, contact us via e-mail parts@officestar.net, by Fax [phone], or toll free parts
number 1-800-950-7262, Monday through Friday 8:00 a.m. - 5:00 p.m. Pacific Time.
BP-CLFEX
EXECUTIVE CHAIR
ASSEMBLY INSTRUCTIONS

LIMITED WARRANTY
INSPIRED by Bassett®Warrants, to the original purchaser its products to be free from defects in material and workmanship for a period of
5 years. Defects and damage from misuse, abuse, negligence, alteration, accident, vandalism, rusting, acts of nature or any other event
beyond the control of INSPIRED by Bassett®is not covered. The warranty does not cover cosmetic damage that may result from normal
use. Liability for incidental or consequential damages is excluded. The user assumes all risk of injury resulting from use of this product. This
warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
To make a warranty claim, contact Customer Service, provide model number, sales receipt and description of the problem. It is the
customer’s responsibility to prepay freight on any components returned to the factory. INSPIRED by Bassett®will pay return freight on
components covered under terms of warranty.
WARNING
1. Do not use this product unless all screws and bolts are securely tightened.
2. Check that all screws and bolts are tight every three months or as needed.
3. Dispose of packing material properly. Do not use plastic cover as head covering. It may cause suffocation.
4. Do not use this product as a stepladder.
5. Use this product for its intended purpose only.
6. 250 lb. weight limit.
7. Intended for residential use only.
Contact us via e-mail parts@officestar.net, by Fax [phone], or toll free parts number 1-800-950-7262, Monday through
Friday 8:00 a.m. - 5:00 p.m. Pacific Time.

PARTS LIST
(2) Pneumatic Cylinder (1 PC)
(1) Base (1 PC)
(3) Chair Body (1 PC)
HARDWARE LIST
DRAWINGNO DESCRIPTION SIZE
A
QTY.
n / a 4 PCSPlastic Plug

STEP 1:
STEP 2:
(2)
(3)
(3)
(1)
(A)
Carefully place Pneumatic Cylinder (2) into Base (1). Place Chair Body (3) on top of Pneumatic Cylinder (2) and apply
downward pressure.
Cover holes in arms of Chair Body (3) using two Plastic Caps (A) for each arm.

FEATURES
FURNITURE CARE:
- Dust with a soft cloth following the grain pattern of the wood.
- Dust often to remove the everyday abrasive particles from the wood surfaces.
- Before dusting, moisten cloth lightly with a spray product.
- Wood finishes also benefit from an occasional polishing.
Contact us via e-mail parts@officestar.net, by Fax [phone], or toll free parts number 1-800-950-7262, Monday through
Friday 8:00 a.m. - 5:00 p.m. Pacific Time.
• PNEUMATIC SEAT HEIGHT ADJUSTMENT
To raise seat remove pressure from seat and lift lever (1). To lower
seat height sit on chair and lift lever (1).
NOTE: It is normal for chair to slightly lower under body weight.
• TILT TENSION ADJUSTMENT
To adjust tilt tension, Turn knob (2) clockwise to increase tension
and counter-clockwise to decrease or ease tension.
NOTE: Be careful not to loosen back tilt adjustment knob completely.
2
1