BatteryMINDer SCC1224 User manual

INSTRUCTION MANUAL
Models SCC1224
&
Aviation Models SCC1224-AA-S2, SCC1224-AA-S3 & SCC1224-AA-S5
SOLAR CHARGER –MAINTAINER –DESULFATOR
WITH TEMPERATURE COMPENSATION FOR USE WITH
20 WATT SOLAR PANEL
w ww . B a tteryM I N D ers. com
B a tteryM I N D er®
READ AND SAVE THESE INSTRUCTIONS

B a tteryM I N D er® SCC1224
2
Rev. A041221 P/N SCC1224-MNL
Table of Contents
OVERVIEW..................................................................................................3
MOUNTING INSTRUCTIONS.......................................................................3
BATTERY CONDITION INDICATOR .............................................................4
TESTING BATTERY ......................................................................................4
FAQs ........................................................................................................4,5
WARRANTY ................................................................................................6
REGISTRATION …………………………………………………………………………………….7

B a tteryM I N D er® SCC1224
3
Rev. A041221 P/N SCC1224-MNL
Please read these simple instructions before making any attempt to permanently or
temporarily install your B a tteryM I N D e r® SCC1224 Solar Charger –Maintainer –Desulfator
controller and solar panel.
OVERVIEW
Note: Your battery(s) needs to be in “good” condition to gain the full benefits from your
B a tteryM I N D er® Solar Charger –Maintainer –Desulfator. By “good” we mean no shorted
cells, and a “rested” voltage of a minimum 8.50 volts for a 12 volt battery (17 volts for a 24 volt
battery). Your solar panel must be oriented in a direction that will ensure maximum exposure
to the Sun. The solar controller must be mounted in an area where it can be easily seen,
protected from the elements (direct rainfall) and bright sunlight (where it would be difficult to
see the 3 LED status indicators). It is important that the controller is in the same general
temperature environment as the battery(s). The built-in temperature compensation lowers
the charging voltage when the environment is too hot - to prevent out gassing. It raises the
charging voltage when the environment is too cold - to keep the battery fully charged. An
extension is available for a remote temperature sensor (VDC Electronics P/N ABS-248).
MOUNTING INSTRUCTIONS
Use the already attached velcro adhesive pad to either temporarily or permanently mount the
controller. This will allow you to change its location, should you ever wish to, without leaving
holes behind. You may also use the screw holes provided.
Connect output wires from the solar panel to the solar controller by twisting wires together
and using the correct wire nut (included). Be careful to observe correct polarity. Do one wire
at a time. Do not have solar panel exposed to sunlight while wiring. Cover solar panel to avoid
electrical shock hazards. Do not touch wires together. Connect cord set with ring terminals
supplied (RTA-2415) or battery clamps (BCAA-2415) to battery terminals. Observe polarity
indications on ring end of wires:
RED = + (POSITIVE)BLACK/BLUE = - (NEGATIVE)
Note: Never try to use your SCC1224 solar controller with any other solar panel in excess of
20 Watts total. Doing so will burn out your controller and void your warranty and
guarantee.

B a tteryM I N D er® SCC1224
4
Rev. A041221 P/N SCC1224-MNL
BATTERY CONDITION INDICATOR
Your battery condition indicator (BCI) will give you a quick indication of your battery(s) state of
charge-condition. By properly using your BCI you can determine whether your battery needs
to be charged, is not holding its charge, or needs to be desulfated.
TESTING BATTERY
Press the area on the face of your BCI in raised area marked PUSH.
If all three (3) LEDs light (RED, , GREEN) your battery is “good” = fully charged =
12.5 –13.2 volts on 12 volt battery (25.0-26.4 volts on a 24 volt battery).
If only the RED and LEDs light your battery is “fair” condition = 12.0-12.5 volts
on a 12 Volt battery (24.0-24.0 volts on a 24 volt battery).
If only the RED LED lights your battery is in “poor” condition = 11.5-12.0 volts on a 12
volt battery (23.0-24.0 volts on a 24 volt battery).
IMPORTANT NOTE: Fused lead (located on the positive lead of battery connector): ATC 3
blade type 15 Amp rated. DO NOT ATTEMPT TO BYPASS OR REPLACE WITH HIGHER RATED
FUSE; SERIOUS DAMAGE WILL OCCUR.
FREQUENTLY ASKED QUESTIONS:
Q: Can the Solar B a tteryM I N D er® be used to charge, maintain, and desulfate any size
or type lead acid 12/24 volt battery, such as sealed gel, AGM, deep cycle, marine,
maintenance free electrolyte?
A: YES. B a tteryM I N D er® can charge, maintain, and desulfate any type size 12/24 Volt
non-aviation lead acid battery, regardless of construction or brand.
Q: Can the Solar B a tteryM I N D er® be used to maintain and desulfate more than one
battery at a time?
A: YES, but remember the limitation of the solar panel will determine how much current
output your Solar B a tteryM I N D er® can supply to the battery. Normally 2 parallel
connected medium sized (automotive type) batteries can be maintained if they are in

B a tteryM I N D er® SCC1224
5
Rev. A041221 P/N SCC1224-MNL
good condition (no shorted cells). The batteries must be of the same type (sealed gel,
AGM, deep cycle, marine, or maintenance free) and same size (electrical capacity, i.e.
amp-hours).
Q: Why do the solar LED indicators turn off and then suddenly turn on seconds later?
A: When the Sun goes behind a cloud the solar controller shuts down in order to prevent
the battery from being discharged due to low or no solar energy. As soon as sufficient
solar energy is detected by the solar controller, the LED indicators turn on again and unit
resumes its function as a charger-maintainer-desulfator.
Q: Why doesn’t the GREEN LED start blinking immediately after low solar shut off, when
just before the LEDs turned off the GREEN LED was blinking.
A: For the GREEN charge power LED to blink, the unit must first charge a 12 volt battery to
approximately 14.2 volts (24 volt battery to 28.4 volts. Once it reaches this voltage the
unit automatically switches to a lower float-maintenance level where it holds the
battery’s voltage at approximately 13.4 volts on a 12 volt battery (26.8 volts on a 24 volt
battery). For the GREEN LED to start blinking the unit must first charge the 12 volt
battery again to the 14.2 volt (28.4 volt level on a 24 volt battery). This can take from
several minutes to several hours depending on the battery size and the amount of solar
energy hitting the solar panel.

B a tteryM I N D er® SCC1224
6
Rev. A041221 P/N SCC1224-MNL
Guarantee and Warranty Policy
For All Replacements, Returns or Repairs covered by Guarantee or Warranty please call 1-800-379-5579
x6 (631-423-8220 x6), M-F, 9 A.M. –5 P.M. (ET) to speak with a technician. Have your unit available when
you call. We will ask you for:
Your contact information
Serial Number
Proof of Purchase
90 Day Unconditional Money Back Guarantee.
We are committed to providing superior products to our customers. We are confident you will be satisfied
but if our product falls short of your expectations we will refund your purchase price. No questions asked -
100% unconditional money back guaranteed if purchased on our website. Returns are accepted within 90
days after purchase. Refunds are not applicable to any items that are damaged due to reasons not covered by
warranty. Customer will return product to VDC Electronics, Inc. at their expense.
Five-year Limited Warranty
This Limited Warranty covers your B a tte ryM I N D e r® Solar Charger for a period of five years and the Solar
Panel for two years from the date of original purchase against defective material and workmanship. Defects
reported during the warranty period will be subject to inspection by a VDC Electronics technician and repaired
or replaced at their discretion. Replacements will be new or like-new, similar in performance and functionality
to the original part.
We make no warranty other than this limited warranty and expressly exclude any implied warranty including
any warranty for consequential damages. This warranty is not transferable. This warranty does not cover
damages caused by the owner.
If you must return the unit, the technician will give you a Return Merchandise Authorization Number (RMA #)
and shipping instructions. Unit must be returned freight prepaid together with proof of purchase directly to
VDC Electronics.
VDC Electroncs
155 West Carver Street, S
Huntington, New York 11743
Once we receive the unit it will be repaired or replaced and shipped back to customer, all at no charge,
provided unit is within the Five-Year Warranty period. Expedited shipping is available at extra cost.
Anyone outside the contiguous USA purchasing any of our products must be aware that all shipping costs in
sending and returning of a product for warranty repair or replacement regardless of cause, will be borne by
the purchaser not VDC Electronics, Inc. or any of its resellers.
Please register your unit online within 10 days of purchase on w ww .b a tterym in d ers. com . Due to ever-
changing technology associated with this B a tteryM I N D er® unit, we may be unable to keep you apprised of
significant upgrades, changes, etc. without your registration. The information you provide upon registration
will be used to keep a record of your purchase and will assist in providing support should you ever need to
contact our Technical Support department: [email protected]; 1-800-379-5579 x6 (631-423-
8220) M-F 9-5 (ET).

B a tteryM I N D er® SCC1224
7
Rev. A041221 P/N SCC1224-MNL
REGISTRATION
Please register your unit on-line at batteryminders.com/registration/ within 10 days of purchase. Customers
who have purchased DIRECTLY from us are AUTOMATICALLY registered.
Due to ever-changing technology we may be unable to keep you informed of significant upgrades, changes,
etc. without your registration. The information you provide upon registration will be used to keep record of
your purchase and will assist in providing support should you ever need to contact our Technical Support
department: 1-800-379-5579 x6 (631-423-8220)
B a tteryM I N D er® Solar Model
□SCC1224 □SCC1224-AA-S2 □SCC1224-AA-S3 □SCC1224-AA-S5
Serial Number: ___________________________________________________________________
Place of Purchase: ___________________________________________________________________
Date of Purchase: ___________________________________________________________________
FOR MORE INFORMATION ABOUT B a tte ryM iN D E R® PRODUCTS,
VISIT US ON OUR WEBSITE AT www.batteryminders.com
OR