The oponal EX PHONO 2X module is a dedicated
pre-amplier that will allow you to connect your turntable
to your BC components. The EX PHONO 2X is compable
with MM (Moving Magnet) and MC (Moving
Coil) cartridges.
The EX PHONO 2X module is compable with the following
models: EX222.1 - EX202.1. On the rear side of its models, a
12V output will supply power to the module.
INSIDE THE PACKAGING
1x EX PHONO 2X card
1x Stereo RCA cable
1x 3 pins MOLEX cable / POWER 12V
1x This quick installaon guide
Stereo RCA cable Power cable
3 pins Molex
Note: No tools are required to connect the card to your
amplier and turntable.
Phono card MM & MC
You do NOT NEED TO OPEN your amplier
to connect your EX PHONO 2X card
Before starng the installaon of the EX PHONO card, make
sure that your amplier EX Series is powered o AND
disconnected from the wall power cord.
We invite you to contact our accredited service staons if
your product has been chocked, exposed to moisture or
humidity or if any parts has been introduce inside the
product. Internal fuses replacement is also an operaon
which should be done by accredited technician.
IMPORTANT !
PLEASE FOLLOW THESE STEPS IN THE ORDER INDICATED
Important safety instrucons
Introducon
QUICK INSTALLATION GUIDE