bca Vegas User manual

Page | 1
Vegas Control Panel User Manual
Vegas Button Panel
Vegas Battery and Water Level Panel
Vegas Battery and Gas Level Panel
Vegas Batter Level Panel (without
Water or Gas indicator)

Page | 2
Vegas Control Panel User Manual
Table of Contents
Overview:................................................................................................................................................3
Vegas Button Control Panel:...............................................................................................................4
Vegas Voltmeter with Water Level Panel: ..........................................................................................5
Vegas Voltmeter with Gas Level Panel: ..............................................................................................7
Vegas Voltmeter Battery Measurement Only Panel:..........................................................................9

Page | 3
Vegas Control Panel User Manual
Overview:
The Vegas Control Panel range allows the user a central or distributed point to check:
•Leisure vehicle battery voltage
•Water tank level measurement
•Waste tank full status
•LPG tank volume measurement
The Vegas Control Panel range allows the user to:
•Switch on/off all non-essential electrical appliances and accessories
•Switch on/off the light circuits
•Switch on/off the pump system
•Force the pump to run (for purging the pipes)
•Switch on/off the awning light
The Vegas Control Panel range has visual alerts for:
•Waste tank full indication
•Pump running indication

Page | 4
Vegas Control Panel User Manual
Vegas Button Control Panel:
Master Button
When the Master Button is pressed, the control panel will switch power to all non-essential
accessories.
•Some features, such as lights, will need the Master Button to be switched on to work.
Lights Button
When the Lights Button is pressed, the control panel will switch power to all the interior lights.
•The Master Button must be switched on for this button to affect the lights.
Pump Button
When the Pump Button is pressed, the control panel will switch power to the water pumps.
•Holding down the Pump Button forces the internal pump to run regardless of tank level.
This is to purge the water system.
Awning Button
When the Awning Button is pressed the control panel will switch power to the exterior awning light.
•The Master Button must be enabled to control the awning light.
Master Button
Lights Button
Pump Button
Awning Button
Vegas Button Control Panel

Page | 5
Vegas Control Panel User Manual
Vegas Voltmeter with Water Level Panel:
Display Indicator
The Display indicator on the Vegas Voltmeter Panel is used to display the Leisure Battery voltage and
the Water level, depending on which button is pressed, also depending on the model it will display
sensor alerts
Display Alerts
•If a waste tank is fitted, the lowest indicator (Red) will illuminate when the waste tank is full.
•When the pump is running the 5th indicator (Green) will illuminate to indicate that the pump
is currently running.
Leisure Battery Voltage Button
When the Leisure Battery Voltage Button is pressed, the Display Indicator will illuminate and display
the voltage level of the Leisure Battery.
Note: This will override indicator alerts.
Water Level Button
When the Water Level Button is pressed, the Display Indicator will illuminate and display the water
level reading inside the water tank. The Vegas Voltmeter panel takes a measurement every 8
seconds that the button is held down with the first measurement done as soon as the button is
pressed.
If the Water Level Button is released and pressed again within 8 seconds of the last measurement
then there will be a delay until a new measurement can be taken. This delay is equal to the time left
from the previous measurement and is a maximum of 8 seconds. If more than 8 seconds has passed
since the last measurement then it will read and display immediately.
Note: Holding the Water Level Button overrides indicator alerts.
Display Indicator
Leisure Battery Voltage Button
Water Level Button
Vegas Voltmeter Control Panel
Waiting for 8 second measurement timer to clear

Page | 6
Vegas Control Panel User Manual
Water Level Calibration
When the water level system is used for the first time or the water tank has been filled from a new
water source it is recommended that the user calibrates the water level system, to calibrate the
water level system please follow the points highlighted below:
•Make sure that the water tank has been filled to the desired maximum water level before
starting the calibration process.
Use the following steps to calibrate your Control Panel.
•Hold down both the Voltage Button and Water Level Button for 6 to 8 seconds to enter
calibration mode.
•When you are in calibration mode, the Display Indicator will light up depending on which
water probe you have installed.
•When the panel has entered calibration mode (One of the 3 options below is being
displayed) please release the Voltage Button and Water Level Button.
Pressure Probe
5-Prong Probe
Resistive Probe
•If you wish to cancel the calibration process, press and hold the Leisure Battery Voltage
Button for one second.
•When the calibration process is cancelled the display with flash two times.
•To start the calibration process, press and hold the Water Level Button for half a second and
then release the button.
•If the calibration process was successful, the display will flash three times.
•If the calibration process is successful, the Control Panel will restart and be ready to use.
•If the calibration process was unsuccessful, the display will flash two times.
•If the calibration process fails, restart the calibration process again ensuring that the
water tank is full.
Note: If the calibration process fails and the display flashes 2 times the value is still saved as its
calibration value.

Page | 7
Vegas Control Panel User Manual
Re-calibrating when using a new water source:
If the Vegas Control Panel is being used with the BCA Resistive Water Probe the control panel should
be re-calibrated at full when the water tank is filled up with water from a new water source.
This is because different water sources have different resistivity values due to the dissolved
compounds present in drinking water (Water Hardness/Softness).
If the resistance of the water currently in the tank is different from the resistance of the water the
control panel was calibrated against then the control panel may display incorrectly.

Page | 8
Vegas Control Panel User Manual
Vegas Voltmeter with Gas Level Panel:
Display Indicator
The Display indicator on the Vegas Voltmeter with Gas Level Panel is used to display the Leisure
Battery voltage and the LPG level, depending on which button is pressed.
Display Alerts
•If a waste tank is fitted, the lowest indicator (Red) will illuminate when the waste tank is full.
•When the pump is running the 5th indicator (Green) will illuminate to indicate that the pump
is currently running.
Leisure Battery Voltage Button
When the Leisure Battery Voltage Button is pressed, the Display Indicator will illuminate and display
the voltage level of the Leisure Battery.
Note: This will override indicator alerts.
Gas Level Button
When the Gas Level Button is pressed, the Display Indicator will illuminate and display the gas level
reading inside the gas tank.
Note: This will override indicator alerts.
Display Indicator
Leisure Battery Voltage Button
Gas Level Button
Vegas Voltmeter and Gas Panel

Page | 9
Vegas Control Panel User Manual
Vegas Voltmeter Battery Measurement Only Panel:
Display Indicator
The Display indicator on the Vegas Voltmeter Panel is used to display the Leisure Battery voltage.
Display Alerts
•If a waste tank is fitted, the lowest indicator (Red) will illuminate when the waste tank is full.
•When the pump is running the 5th indicator (Green) will illuminate to indicate that the pump
is currently running.
Leisure Battery Voltage Button
When the Leisure Battery Voltage Button is pressed, the Display Indicator will light up and display
the voltage level of the Leisure Battery. The button on the right of the panel is not used on this
panel.
Note: This will override indicator alerts.
Unused Button
The right-hand button on this panel is unused, pressing this button will not cause anything to
happen.
Display Indicator
Leisure Battery Voltage Button
Button not used
Vegas Voltmeter Battery Measurement Only Panel