98
WARNING
ROAD SAFETY COMES FIRST!
Do not use a hand-held cellular terminal, satellite
phone or mobile when driving a vehicle, unless
it is securely mounted in a holder for speaker
phone operation. Before making a call with a
handheld terminal, satellite phone or mobile,
park the vehicle stationary. Please obey local road
laws for hands-free speakerphone operation.
Speakerphones (hands-free) must be installed
by qualied personnel. Faulty installation or
operation can constitute a safety hazard.
IMPORTANT
Cellular & Satellite terminals or mobiles operate using
radio signals and communication networks. Because
of this, the connection cannot be guaranteed at all
times or under all conditions. Therefore, you should
never rely solely upon any wireless device for essential
communications, for example emergency calls.
» International Commission on Non-Ionizing
Radiation Protection (ICNIRP) 1996
» Verband Deutscher Elektrotechniker
(VDE) DIN-0848
» United States Federal Commission, Radio
Frequency Exposure Guidelines (1996)
» National Radiological Protection Board of
the United Kingdom, GS 11, 1988
» American National Standards Institute
(ANSI) IEEE. C95. 1-1992
• Do not operate your satellite telephone
when a person is within 55cm of the
antenna. A person or object within 55cm
of the antenna could impair call quality
and may cause the phone to operate at
a higher power level than necessary and
expose that person to RF energy in excess
of that established by the FCC RF Exposure
Guidelines.
• As a precaution, please maintain the
maximum body distance possible from the
antenna during call transmission.
Safety Transceiver IsatPhone Pro
Your handset is a low power radio transmitter
and receiver. When it is ON, it receives and
also sends out radio frequency (RF) signals.
(NOTE: Refer to Inmarsat IsatPhone Pro
Manual for additional Information)
• The Inmarsat IsatPhone Pro handset has
an in-built transceiver which is designed
to be used with an external antenna. This
antenna transmits RF energy. The BEAM
antenna (tted via an extension coaxial
cable to the cradle) must be located
more than > 55cm from the human body
(person) when in operation.
• International agencies have set standards
and recommendations for the protection
of public exposure to RF electromagnetic
energy. These standards are based on
extensive scientic review by scientists,
engineers, and physicians from universities,
government health agencies, and industry
groups They review the available body of
research to develop ANSI standard.These
ANSI standards are reviewed regularly for
research development.
IsatDock FCC Information
This equipment has been tested and found
to comply with the limits for a Class B digital
devices, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruction
manual, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment o and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the
equipment and receiver
• Connect the equipment into an outlet on
a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
This device has been designed to operate with
antennas ISD710 AT1595-82, ISD715/ISD720
AT1595-83 and having a maximum gain of 6dB.
Antennas having a gain greater than 6dBi are
strictly prohibited for use with this device.
To reduce potential radio interference to other
users, the antenna type and its gain should
be so chosen that the equivalent isotropically
radiated power (EIRP) is not more than that
required for successful communication
WARNING
Changes or modications not expressly approved
by BEAM Communications could void the product
warranty.
