Beam Garage Vac User manual

Beam Garage Vac
Installation Instructions
by

GarageVacInstallationInstructions
Maintenance
1. Press fit the 45°bend and inlet flap into the tube exiting from the top
side of the appliance and tighten the retaining screw. Orientate to
preferredposition,butsothattheinletflapisintheidealposition.
2.Connectthetwospadeconnectorstothescrewsatthetopoftheinlet
flapandscrewdowntightly.
3. Position the appliance against the wall, marking the position of the
holes through the three foot-plates with a pencil. Ensure appliance is
close enough to a standard plug socket if an extension lead is not being
used.
4.Drillthethreeholestoaccommodatetherawlplugandwallscrews.
5.Screwtheappliancetothewallandplugthevacuumhosein.
6. When the hose is inserted into the inlet, the appliance should
automaticallyturnonandwhenthehoseiswithdrawnitwillswitchoff.
To empty the bag, release the two spring-clips from the side of the lid to
reveal the bag compartment. Remove and dispose of the bag when full,
press the replacement bag firmly over the intake pipe and secure the
lid.
Replacement bags are available in packs of three from our sales
department,re-ordercode:6007.
Garage Vac Installation Instructions, Issue 2, 24.03.10, T.H.E Ltd, E&OE.
If you require any help with the installation of the Garage Vac
system in your home, please contact Beam Central Vacuums on
0845 260 0123
Our service department will be happy to help 9am-5.30pm Monday to Friday.