Bear Wood Furniture Raffy User manual

‘Raffy’ the Rotating
Bookcase
Assembly Instructions
Please ensure you’ve read our ‘Safety &
Usage’ document before you begin.
Please use the hex key provided and do
not use power tools as they can over
tighten the screws and damage the
wood.

1. Lay out the contents of your package (Picture 1)
2. Take the two parts of the circular base and slot together using the dowels into
the corresponding holes on the opposite piece.
3. Tighten the dowel fixings using the hex key provided (Picture 2)
4. Take one of the side pieces, ensuring the straight edge is at the bottom, with the
curved edge at the top. (Picture 3)
5. Find the square piece with the 4 metal holes, ensuring these are facing down.
Screw from the outside of the side piece through into the pre drilled holes on the
side of the bottom square piece. (Picture 3)
There are two pairs of holes close together, use the bottom pair for the square
pieces
6. Find the two square pieces with the single central holes, and secure again from
the outside of the side piece using the screws and Alan key (Picture 4).
7. Finally find the square piece with no holes and secure in the position at the top
of the side piece below the curved end.
8. Repeat for the other side creating the shelving spaces (Picture 5)
9. Take the grooved side shelves and secure from the inside again screwing
through the pre drilled holes using the Alan key provided (Picture 6, 7 & 8)
Don’t forget to secure the ‘rainbow’ shaped dividers on the two middle shelves
using the single central pre drilled hole, and the washers and screws
provided.
These can be rotated and aligned as you please.
10. Take the rotating component and attach to the circular base using the
mushroom head bolts with the Alan key into the metal threaded holes
(Picture 9)
11. To attach the base (which now has the metal rotating bracket secured to it) to
the assembled bookcase, we recommend flipping the bookcase on it’s front
/ back as seen in the photo below. It also makes it easier if you raise the
bookcase up off the floor, or sit it over the edge of a table or worktop
(Picture 10)

- The large hole on the base allows you to see and align the bracket over the metal
threaded holes in the bottom of the bookcase.
12. You can then insert the mushroom bolt and tighten and secure using the Alan
key through the hole as seen pictured right (Picture 11)
Tip! Do not fully tighten the bolt initially to enable you to align the other holes,
once all bolts are aligned then fully tighten to secure the rotating component.
13. Rotate the base and hole round to the remaining threaded holes and secure
the bracket to the bottom of the bookcase.
14. Stand the bookcase up on its base and give it a check and test spin to ensure
its assembled securely and safely (Picture 12)
Please note!
We strongly advise you secure your bookcase to a skirting board or wall stud using
the wall brackets and wood screws provided (Picture 13)
Use the smaller (16mm) screws to secure the
bracket down into the base.
The longer (30mm) screws are used to secure
into skirting boards and or wall studs or
wall plugs.
We hope you enjoy your new Rotating Bookcase!
Ensure children using the rotating
bookcase are supervised at all times!
Bear Wood Furniture Ltd
Please refer to our ‘Usage & Safety’ document for additional guidance.
Contact us @bearwoodfurniture_ // [e-mail]

Picture 1
Picture 2
Picture 2
Picture 2
Picture 3
Picture 4

Picture 5
Picture 6
Picture 7
Picture 8

Picture 9
Picture 10
Picture 11
Picture 12
Picture 13