Beijing DAM-E3311 User manual

DAM-E3311
User’s Manual
BeijingART Technology Development Co., Ltd.

DAM-E3311User’sManual V6.10
2
DAM-E3311 Module
Terminal Distribution
Features
Optical Fiber to Ethernet Interface Converter
¾Network ports: 1-ch, 10/100Mbps, RJ-45 interface
¾Fiber interface: Multi-mode fiber, center wavelength is 1310nm, SC interface (ST can be
customized )
¾Transmission distance: Ethernet: 100m, Fiber: 2000m
¾Supports full/half duplex transmission
¾Supports MDI / MDIX auto crossover
¾Embedded switch control, with auto-negotiation function
¾Embedded memory buffer, supports store and forward transmission
¾Power supply: +10~+30V
¾Operating temperature: -10℃~65℃
¾Operating humidity: 20~95%( Non-condensing)
¾Power consumption: 3W
HardwareDescription
¾Power Terminal: 3.81mm pitch, 2-pin green terminal

DAM-E3311User’sManual V6.10
3
¾Power Line: recommended to use more than 0.5 mm2(AWG20) wire
¾Network Cable: CAT-5 series cable
¾Conductive Film: when we use it, the module must be connected to the earth to prevent electrostatic damage
¾Indicator: there are three indicators, one power indicator (POWER), one Fiber connection indicator (Link
(100BASE-FX) and Network indicator (100/10M (Ethernet)), the following is the specific status:
Indicator Color Status Description
on +10~+30V power supply is connected
POWER Green
off No power
on Connect fiber-optic network
flashing working
Link (100BASE-FX) Green/Yellow
off Fiber-optic network is not connected
on Connected to the Ethernet
flashing working
Green（Link）
off Ethernet is not connected
on Connect to the 100MbpsNetwork
100/10M (Ethernet)
Yellow
（Speed）off Connect to the 10MbpsNetwork
Wiring Diagram

DAM-E3311User’sManual V6.10
4
Installation Instruction
DAM-E3311can be installed in standard DIN rail inside the cabinet, it also can be installed by stacking
mode.
Fig.1 standard DIN installation
Fig.2 stack installation