Belkin F5L075USB User manual

© 2009 Belkin International, Inc. All rights reserved. All trade names are registered trademarks of respective manufacturers listed.
8820-00400 • F5L075-USB
belkin.com
Belkin Tech Support
US: 310-898-1100, ext. 2263
800-223-5546, ext. 2263
UK: 0845 607 77 87
Australia: 1800 235 546
New Zealand: 0800 235 546
Europe: www.belkin.com/support
FCC Statement
(15.21)
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to
operate the equipment.
15.19 (a)(3)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC Statement
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device

Quick Installation Guide
Wireless Mouse

Wireless Mouse
1Battery Compartment
Cover
3The Receiver
4Receiver’s
Connect Button
2On/Off Button
5
Mouse’s
Connect Button

Quick Installation Guide
Setup Instructions
Connect the mouse and receiver when you use the mouse for the first time and when
replacing batteries.
1. Remove the battery compartment cover and install two AAA alkaline batteries as
indicated by the polarity symbols (+/-), then replace the cover.
2. Turn on the mouse.
3. Plug the receiver into an available USB port.
4. Press the USB receiver’s Connect button.
5. Press the mouse’s Connect button.
Note:
• The unit will go into stand-by mode after a few seconds of idling. Slide the mouse
around to wake it up.
• The unit will go into sleep mode after 6–8 minutes of idling and the LED will go off.
Click the mouse button to wake it up.