BELLAGIO Cast Aluminium Lounger 881.42.001.16 User manual

ASSEMBLY INSTRUCTION
CAUTION:
1. Please read these instructions carefully before assembling. Count and organize all parts before you begin.
2. Assemble product on clean soft surface, such as a piece of carpet, so as to prevent the surface paint of parts from
scratching off.
PARTS&HARDWARE LIST
No.
DESCRIPTION
QTY
A
SEAT
1
B
BACK
1
C
LEGS
2
D
ARM (LEFT&RIGHT)
2
E
LEVER BACK
1
F
LINKING STRIPOF TYRE
1
G
TYRES
2
H
M8 HEADLESS
SCREWS
M8*45
2
M8*50
2
M8*32
4
I
CAPNUT M10
2
Bolt Cap M8
10
J
M8×55 FLAT HEAD SCREWS
2
K
M8×45 FLAT HEAD SCREWS
2
L
COPPER RINGER
2
M
M8 WASHER
10
N
BIGWASHER M10*25
2
O
M8 NUTS
10
P
FEET PADS
4
Q
SPRINGWASHER
10
R
SPANNER
2
ASSEMBLY：
1. Connect seat (A) to the left or right arms (D) with (H, M, Q, O).
2. Fix legs(C) to seat with (H, M, Q, O).
3. Install (L) the ends of the (F),then slip(G)on and fixed with (N,I).Connect left or right arms(D),linking strip or
type with(F,L,N,I).
4. Adjust the installed deck chair to even, that is to adjust the legs, arms to the same place, then tighten the screws.
5. Connect back (B) and (E) with (M, Q, I), do not over tighten.
6. Connect back (B) to the left or right arms (D) with (K, M).
7. Connect (E) and (B) with (J, M, P), do not over tighten.
8. Put the bolt cap (I) onto the M8 NUTS and BIG WASHER M10.
9. If (F) is on the adjustment file, please adjust it by (J).
10. If not even, adjust feet pad (P) Over tightening can damage aluminum parts
PLEASE DO NOT OVER TIGHTEN
(Aluminum is soft metal, over tightening may strip thread or break parts)

Cast Aluminium Lounger
Article Code: 881.42.001.16
ASSEMBLY INSTRUCTIONS
Please read the Instruction carefully before assembly. Make
sure you have all the parts and hardware as identified on the
parts list.