Belmont garden Rustique bird feeder & bath User manual

Rustique Bird Feeder & Bath

OWNERS MANUAL

CONTENTS:

BIRD FEEDER FOUNTAIN DIAGRAM:

Bird Feeder 2x Perches

S Hook

Battery

Compartment

Perches X 2

1-4 Hour

Timer

Power On/OFF

Auto

Battery Cover

Water Level: Fill

Until Water

Covers Water

Pump

Handle

S Hook

Dancing Water

Attachment

Bird Seed

Compartment

Bird Feeder

Fountain Body

Control Switches

Retaining Screws

INSTRUCTIONS:

1. Place Bird Feeder on a flat, level surface. Clip the S Hook to the handle.

2. Slide the Perches (2) into the holes on each side of the Bird Feeder, make sure handle is fully upright. Slide in until the perch snaps into place.

3. Fill bowl with water, the water level should just cover the water pump housing. (See fountain diagram). Fill Bird Seed compartment with seed.

NOTE: Use a small trowel to scoop bird seed into Bird Seed Compartment.

4. Turn on your new Belmont GardenTM Fountain and enjoy.

OPERATING YOUR BIRD FEEDER FOUNTAIN:

Note: The switches are located on the bottom of the Bird Feeder Fountain (see fountain diagram).

1. Switch Position On: Turns the fountain on and fountain runs until fountain is manually turned off. Unless fountain is turned off, it will run until the

batteries are exhausted.

2. Switch Position Off: Turns Fountain Off

3. Switch Position Auto: Runs the fountain automatically in conjunction with the 1-4 hour timer switch. In position 1, runs for 1 hour with automatic

shut off, turns on again daily at the same time. In position 2, runs for 2 hours with automatic shut off, turns on again daily at the same time. In

position 3, runs for 3 hours with automatic shut off, turns on again daily at the same time. In position 4, runs for 4 hours with automatic shut off,

turns on again daily at the same time.

Perch Installation

Need Help?

Call us for assistance at:

1+ (619) 449-2392

or you can email us at:

customercar[email protected]

Our Customer Care Department is available:

Monday - Friday 8:30am to 4:00pm PST

11:30am - 7:00pm EST

Dancing Water

Attachment (OPTIONAL):

When fountain is not running, connect

the Dancing Water Attachment to the

outlet in the middle of the Bird Feeder Bowl.

INSERTING & CHANGING BATTERIES (4D CELL BATTERIES NOT INCLUDED):

1. Drain water if necessary. Ensure fountain is not running and turn the Bird Feeder upside down for access to the battery compartment.

2. Turn battery housing counter clockwise and lift out battery assembly (Figure 1). Please note location of notch in the housing and battery cable retaining clip (Figure 1a).

3. Turn the Bird Feeder right side up and set battery compartment next to Bird Feeder housing (Figure 2).

4. Unscrew the battery retaining screws and lift out batteries paying attentiion to battery positions (Figure 2a).

5. Insert 2 batteries with the (+) side facing up and 2 batteries with the (-) facing down (Figure 2b).

6. Re-Install the battery retaining screws (Figure 2a).

7. Re-insert the battery assembly into the Bird Feeder and turn clockwise (Figure 3). Be sure to align notch in the housing and battery cable retaining clip (Figure 1a).

Figure 2a

Figure 2b

Figure 2

1.5VX4

Figure 3

Figure 1

Figure 1a

Dancing Water

Attachments

(NOTE: Use a small trowel to scoop bird seed into Bird Seed Compartment.)

001161 BGRBFB rev 4a us

Santee, California 92071 | World Wide Patents Pending | Email: [email protected] | On the web: www.belmont.garden

Facebook & Pinterest: Belmont Garden | Instagram: @belmontgarden Twitter: @yrdllc

Made in China | Designed in the USA

TROUBLESHOOTING: CARE AND MAINTENANCE:

Call us for assistance at 1+ (619) 449-2392 or you can email us at: customercar[email protected]

Our Customer Care Department is available: Monday - Friday 8:30am to 4:00pm PST / 11:30am - 7:00pm EST

COLD STORAGE

Drain the water from fountain prior to the first freeze of the season. Clean and dry the fountain of all water. Remove the batteries and the

water pump and bring it indoors. (Now is a great time to clean the pump to remove any debris that may have accumulated throughout the

year.) Store in a warm dry area.

CLEANING YOUR FOUNTAIN

In order to keep your fountain in tip-top shape and free of algae, you should clean your fountain every two months. To clean your fountain,

drain of all water and disassemble. Use a mild soap and a soft cloth to clean the parts of your Belmont Garden™ Fountain. DO NOT

SCRUB YOUR FOUNTAIN, AS THIS COULD CAUSE DAMAGE TO THE FINISH OF YOUR BELMONT GARDEN™ FOUNTAIN.

CLEANING THE WATER PUMP’S PARTS

WATER PUMP AIR FILTERS

After about six weeks of usage, you may want to clean the water pump’s

filter and impeller to keep your Belmont Garden™ Fountain in tip-top shape.

Step 1: Remove the water pump cover by grabbing the sides and

pulling it up and off the unit.

Step 2: Remove the Air Filter from in front of the Water Pump.

Step 3: Rinse the Air Filter until all debris has been removed. Then replace

the Air Filter back in front of the Water Pump and then replace the

Water Pump’s cover.

WATER PUMP IMPELLER

The impeller inside of the Water Pump is what pushes water up through your fountain, allowing you to enjoy the soothing sounds and

wonderful sights of your Belmont Garden™ Fountain. After long periods of usage, this part will need to be cleaned to make sure your fountain

runs optimally.

Step 1: Remove the front of the Water Pump

by grabbing the sides of the front panel and

pull it off the unit.

Step 2: Remove the impeller chamber cover.

This is tightly fitted on to the impeller chamber,

but will come off.

Step 3: Remove the impeller from its chamber.

Step 4: Rinse the impeller until all debris has

been removed. Then replace the impeller in the

impeller chamber, put the impeller chamber

back on and then replace the pump’s front panel.

LIMITED ONE YEAR WARRANTY

This product has a one year limited warranty on all materials and workmanship. Belmont Garden™ warrants the original purchaser of this product that the product will be free from manufacturing defects in workmanship and material for a

period of one (1) year from the date of original purchase. If within one (1) year this product fails due to defect in material or workmanship, Belmont Garden™ will repair, replace or supply any defective part at their option. The purchaser must

contact Belmont Garden™ and provide a description of the defective part, including digital pictures if requested, with this original purchase documentation as validation of warranty coverage. This warranty does not cover or apply to: (a)

damage to the product due to misuse, mishandling, and abuse, (b) products not used in accordance with instructions, (c) product not assembled or installed according to instructions, and (d) normal wear and tear.

Please read first before returning:

Please call us for assistance at

1+ (619) 449-2392

or email us at customercar[email protected]. Our Customer Care Department is available: Monday - Friday 8:30am to 4:00pm PST, 11:30am to 7:00pm EST. If you have any questions

regarding assembly, parts, or operation, please visit our website at www.belmont.garden. You will find instructional videos on how to assemble and operate your fountain and will keep you up to date on our newest products. You can also email

us with any questions you have. This product comes with a one year limited warranty against materials and workmanship.

PRIMING THE WATER PUMP

If you find the water pump is running, but water is not

flowing from your fountain, you can try priming the

water pump:

First ensure that the pump is completely submerged

in water and grab both sides of the Hanging Bird

Feeder and shake gently for about 10 seconds.

REPEAT THIS as needed, this will help dislodge any

air bubbles that may be in the air filter/pump

assembly (Figure 1).

Hanging The Bird Feeder:

Ensure that whatever is used to hang the Hanging

Bird Feeder from is strong enough to adequately

support the weight of birds and the Bird Feeder when

filled with water and bird seed.

Watering Requirements:

Due to evaporation, ensure that the Hanging Bird

Feeder’s water pump is always covered with water.

High Wind:

Consider taking the Hanging Bird Feeder indoors

during high wind conditions to prevent accidental

breakage of the Bird Feeder.

Debris:

Remove any debris that may fall into the Hanging

Bird Feeder. The water pump performance may be

impeeded if the intake to the pump is blocked by any

debris.

IMPORTANT BATTERY SAFETY INSTRUCTIONS:

PROPOSITION 65 WARNING: This product can expose you to chemicals including lead and lead compounds which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to

www. P65Warnings.ca.gov.

WARNING: When using electric devices, basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury, including the following:

WARNING: 1. Do not incinerate the battery even if it is severely damaged or is completely worn out. The battery can explode in a fire. Check with municipal codes in your area for possible special disposal Instructions.

2. If liquid leaks from the battery cell, discontinue use immediately and dispose of Properly.

3. Use only 4-1.5V D Cell Batteries..

4. Do not attempt to disassemble, remodel or destroy the battery, as it may cause battery leakage, fire, or bursting; and could also create sulfuric acid spills from the battery resulting in possible burns to a person (or you) and damage to the immediate

environment.

5. Never dispose of batteries in the garbage. Disposal of batteries in the garbage is unlawful under state and federal environmental laws and regulations. Always take used batteries to your local battery-recycling center.

Step 1

Step 1 Step 2 Step 3

Step 2 Step 3 Step 4

Figure 1

Shake

10 sec

Ensure

Water

Covers

Pump

Rustique Bird Feeder & Bath

OWNERS MANUAL