PAGE 3
Assembly Instructions
Model: ECO-6
HINGE
TO RELEASE
PULL LEVER
DOOR
SIDE
D1
Remove (2) Doors (D1) from Upper Storage (D) (see Figure 3).
Step 5
Figure 3
2x
Place Upper Storage (D) on top of the Lower Cabinet (A)
Secure with (4) 1/4-20 x 1-3/4” Flat Head Screws (D2) (see Figure 4).
(Note:Make sure to have an assistant hold the Upper Storage
in position to keep it from falling off).
Step 6
D
D
Figure 4
D2
A
4x
Step 7
5mm allen wrench (see Figure 5).
You can mount the cabinet to the floor at this point by
mounting the (4) Floor Mounting Brackets (A8) to the floor
using proper fasteners for the floor being mounted to.
Adjust the (4) Leveling Feet (A7) to the desired height using a
done at a later time but be sure to do so before access to the
feet/floor brackets is unavailable (prior to reinstalling covers and
panels. Cabinets placed up against a wall is one case where you
should wait to mount the cabinet to the floor.
Both leveling the cabinet and mounting to the floor may be
IMPORTANT
Figure 5
A7
4x
A8
Step 8
ECO-6 Electrical Schematic &
Instruction sheets.
NOTE: Cabinets placed against a wall
must have electrical access cut through
the rear base or Lower Rear Panel.
Make electrical connections per the
