Belson Outdoors SANSTAND SAN1-2000 User manual

Model # SAN1-2000 Instructions Sheet
www.belson.com
SANISTAND™ HAND SANITIZER STAND WITH FOUR DISPENSERS
We recommend reading through the entire assembly instructions prior to proceeding
with installation, service and maintenance. All references to left and right throughout this
guide are as viewed from the front.
DIMENSION
Height
Width
Depth
Base Capacity
Weight Empty
Number of Single Dispenses
Maximum Foam Dispensers
IMPERIAL
66
in
28 in
28 in
23 gal
31 lbs
5333
METRIC
168 cm
71 cm
71 cm
87.1 L
14 kg
5333
4000 mL
SPECIFICATIONS
627 Amersale Drive
Naperville, IL 60563
Phone: [phone]
Fax: [phone]
[email protected]

www.belson.com
SAN1-0001G - Base
PC-000554 - 1” Plug
Gray w/Tether
(1) PC-000345 - O-Ring
PC-000762 -
Locking Rod
PC-000205M - Lock
SAN1-0005 -
Dispensing Pipe
SAN1-0004G -
Foam Dispenser Holder
(2) PC-000158 -
Self-Tapping Screws
(4) FD1-1000 -
Hand Foam Dispenser
(16) PC-000105 - Rivet
(16) PC-000106 - Washer

www.belson.com
General Use and Information
Assembly Instructions
NOTE: All drilling will require a 13/64” bit.
Step 1. Insert the SAN1-0005 - Dispensing Pipe into the SAN1-0001G - Base.
Step 2. Line up the pre-drilled holes of the base and dispensing pipe. Insert
a PC-000762 - Locking Rod through the holes of the base and dispensing pipe
and push through to the other side. Place a PC-000205M - Lock onto the lock-
ing rod and secure in place.
Step 3. Place the SAN1-0004G - Foam Dispenser Holder onto the dispensing
pipe, lining up the corners of the holder with the corners of the base (making
Step 4. While pushing down on the top of the holder, drive (2) PC-000158 Self-
Tapping Screws through the two drill spots located along the top of the holder
and through the dispensing pipe.
Filling a Dispenser:
ll a dispenser, push up on the tab from underneath the dispenser and pull
down the cover. Fill with Rid-It™ - Foam Hand Sanitizer (follow the instructions
located on the sticker inside of the foam dispenser). Order Part #FD1-0001 for a
lls, available from PolyJohn.
Filling the Base:
ll the base with water or sand (in order to create enough ballast to keep from
being tipped over), unlock the lock from the base and remove the lock, locking
rod and dispensing pipe. Fill with either water or sand and reinsert the dis-
pensing pipe, locking rod and lock.
Note: lling with sand, make sure to tilt the base on its side to keep the bottom
raised area free from sand for proper re-installation of the dispensing pipe into the base.
Draining the Base:
lled with water, simply loosen the PC-000554 Plug located
nished draining. If
lled with sand, unlock the lock, remove the lock and locking rod and pull out
the dispensing pipe. Turn the base upside down and empty. Reinsert the dis-
pensing pipe, locking rod and lock when empty.
~~Assembly Tools Required~~
•Drill with a Phillips Bit
or a Phillips Head Screwdriver
Full Scale Fastener Drawing
(2) PC-000158
Self-Tapping Screws