Bench Dogs Rail Square User manual
INSTRUCTION MANUAL
Rail Square
INSTRUCTIONS FOR
90° angle cuts ◄
45° angle cuts ◄
Bevel-edged cuts ◄
Using the b-collars ◄
FIND ALL INSTRUCTION MANUALS AT
WWW.BENCHDOGS.CO.UK
CONTACT@BENCHDOGS.CO.UK WWW.BENCHDOGS.CO.UK Q E M
FOR MORE INFORMATION PLEASE VISIT
Screw the MFT grooved dogs in the
holes as shown.
Push the dogs through your
MFT Table holes.
Slide your rail through the guide on the
square and tighten the thumbscrews to
secure the rail in place - this setup will
enable you to cut at 90° angles.
STEP 1
STEP 2 STEP 3
Instructions for 90° angle cuts
You will need 1x MFT grooved 45°
adapter which can be bought separately.
Screw one MFT grooved dog in the
right hand hole (marked red) and a MFT
grooved 45° adapter in the smaller hole
on the left (marked yellow).
Push the dogs through your MFT Table
holes at a 45° angle.
Slide your rail through the guide on the
square and tighten the thumbscrews to
secure the rail in place - this setup will
enable you to cut at 45° angles.
STEP 1 STEP 2 STEP 3
Instructions for 45° angle cuts
CONTACT@BENCHDOGS.CO.UK WWW.BENCHDOGS.CO.UK Q E M
FOR MORE INFORMATION PLEASE VISIT
Screw either the 30mm Bevel Adapters
or the 60mm adapters – depending
on the thickness of the board you are
cutting – into the holes as shown.
Place the square/rail over the bevelled
edge of your work piece to enable you
get maximum stability to make the cuts
you require.
With either of the grooved adapters in
place you can use our b-collars to adjust
the height of the square to t perfectly
with the thickness of your work piece,
simply tighten the grub screws (circled)
using the commonly spaced grooves to
x in place.
STEP 1 STEP 2 STEP 1
Instructions for using the b-collarsInstructions for bevel-edged cuts
CONTACT@BENCHDOGS.CO.UK WWW.BENCHDOGS.CO.UK Q E M
FOR MORE INFORMATION PLEASE VISIT
Table of contents
Other Bench Dogs Tools manuals
