beno+ Reevo User manual

Welcome
To
The
Family

What’s
in
the
box?

Reevo
Crank arms
and pedals
6mm and 4mm
Allen key
Battery Battery charger
Battery keys User manual
Beno bag
(Optional)
Fender set
(Optional)
Electronic bell
(Optional)
Crank bolts

Ambient
light
sensor
Battery
Rear light
Front light
Motor
Wheel lock
USB Charging Port
Storage hook

Assembly

Remove your Reevo out of the box.
Step 1

Fully extend the kickstand for ease of assembly.
Step 2

Your Reevo is packaged with the handlebar
parallel to the wheels and frame.


Stand in front of the bike and
face the bike. Align the front
wheel so that it is parallel to
the frame.
Hold the front wheel firmly
in between your knees and
rotate the handlebar
anticlockwise until it is
perpendicular to the frame.
Step 3 Step 4

Use the 6mm Allen key to
tighten the top bolt of the
bike stem.
Step 5

Use the 4mm Allen key
to tighten the two side
bolts of the bike stem.
Tighten the top bolt first
before tightening the
side bolts.
Step 6


The left crank arm and right
crank arm are different. You can
differentiate them by identifying
the “L” and “R” markings.
“L” is for the left crank arm.
“R” is for the right crank arm.
 

Insert the right crank arm followed by a crank bolt
into the right side of the housing by hand.
Step 7

Use the 6mm Allen key to tighten the
crank bolt.
Repeat the steps above for the left
crank arm.
Step 8

Adjust the saddle height to
fit your comfort.
The optimum saddle height is
when there is a slight bend in
your leg with the pedal in its
lowest position.
Step 9 

Press on both sides of the
battery lid simultaneously
to unlatch and open it.
Step 10

Insert a nano SIM card into the
SIM slot on the battery dock.
We recommend using a 4G SIM
card with a minimum data of 100
MB.
Step 11


Insert the fully charged battery
and close the battery lid.
Step 12

Technical
Specifications