BenQ MX818ST User manual

or

Projection dimensions
Diagonal
Inch mm
H
(mm)
W
(mm)
Vertical offset
(mm)
Distance from screen
(mm)
Screen size
The screen aspect ratio is 4:3 and the projected picture is 4:3
All measurements are approximate and may vary from the actual sizes.
BenQ recommends that if you intend to permanently install the projector, you should physically test the
projection size and distance using the actual projector in situ before you permanently install it, so as to make
allowance for this projector's optical characteristics. This will help you determine the exact mounting position
so that it best suits your installation location.
80 2032 1219 1626 988 183
100 2540 1524 2032 1235 229
120 3048 1829 2438 1481 274
150 3810 2286 3048 1852 343
180 4572 2743 3658 2222 411
200 5080 3048 4064 2469 457
220 5588 3353 4470 2716 503
240 6096 3658 4877 2963 549
270 6858 4115 5486 3333 617
300 7620 4572 6096 3704 686
Screen size
Screen
Center of lens
Projection distance
<H>
<W>
Vertical offset
MX818ST/MX819ST

Projection dimensions
Diagonal
Inch mm
H
(mm)
W
(mm)
Vertical offset
(mm)
Distance from screen
(mm)
Screen size
The screen aspect ratio is 16:10 and the projected picture is 16:10
All measurements are approximate and may vary from the actual sizes.
BenQ recommends that if you intend to permanently install the projector, you should physically test the
projection size and distance using the actual projector in situ before you permanently install it, so as to make
allowance for this projector's optical characteristics. This will help you determine the exact mounting position
so that it best suits your installation location.
Screen size
Screen
Center of lens
Projection distance
<H>
<W>
Vertical offset
MW820ST
80 2032 1077 1723 842 54
100 2540 1346 2154 1053 67
120 3048 1615 2585 1263 81
150 3810 2019 3231 1579 101
180 4572 2423 3877 1895 121
200 5080 2692 4308 2105 135
220 5588 2962 4739 2316 148
240 6096 3231 5169 2526 162
270 6858 3635 5816 2842 182
300 7620 4039 6462 3158 202

Wall mount installation
Minimum installation requirements
Computer
Resolution: XGA
Image
Resolution: XGA
Diagram
Reference
SMART
Board
660
Smart
Board
680
Promethean
ActivBoard
164
Promethean
ActivBoard
178
RM
ClassBoard2
77.5
Hitachi
StarBoard
FX-63
StarBoard
FX-77
Image Diagonal (inches)
Image Height (mm)
Image Width (mm)
Distance from floor to
bottom of image (mm)
Distance from screen
surface to projector
rear case (mm)
Distance from top case
to the top of image
(mm)
Distance from top of
wall mount to ceiling
(mm)
Minimum Ceiling Height
(mm)
Computer Resolution:
WXGA
Image Resolution: WXGA
Diagram
Reference
SMART
Board
685
Promethean
ActivBoard
387
Hitachi
FX-TRIO-
88W
Hitachi
FX-DUO-
88W
Image Diagonal (inches) D 87 87 88 88
Image Height (mm) H 1171 1171 1181 1181
Image Width (mm) W 1874 1874 1887 1887
Distance from floor to
bottom of image (mm) f 900 900 900 900
Distance from screen surface
to projector lens (mm) a 916 916 926 926
Distance from top case to
the top of image (mm) b 6.8 6.8 7.5 7.5
Distance from top of wall
mount to ceiling (mm) c 50 50 50 50
Minimum Ceiling Height
(mm) e 2461.8 2461.8 2472.5 2472.5

Wall mount installation
Minimum Ceiling Height (mm) = f+H+b+60+274+c
20
60
150
180
60
c
b
a
H
W
D
f
e
274
Ceiling
floor
Distance from floor to
bottom of image
screen
Projection
area Wall plate
232.6
•The dimensions are based on the BenQ wall mount (P/N: 5J.J4R10.001).
•All measurements are approximate and may vary from the actual sizes. BenQ recommends that if you
intend to permanently install the projector, you should physically test the projection size and distance
using the actual projector in situ before you permanently install it, so as to make allowance for this
projector's optical characteristics. This will help you determine the exact mounting position so that it best
suits your installation location.
•The dimensions supplied are offered as a guide only and may differ depending on several factors relating to
any specific installation.
•The dimensions are based on the projector being configured with zero keystone correction.
•The dimensions assume that the wall mount arm is positioned 90° from the bottom case of projector and
screen surface.

21
1
4
ON
2
3
5

OFF
1
2
X2