Bertazzoni 3100768 Guide

BERTAZZONI
INSTALLATION MANUAL & USER
INDUCTION RANGETOP
3100768
WWW.BERTAZZONI.COM
LCI

2
/ Table of contents
TABLE OF CONTENTS
INSTALLATION
WARNINGS ___________________________________________________________________
DATA RATING LABEL ___________________________________________________________
BEFORE INSTALLATION ________________________________________________________
VENTILATION PREPARATION ____________________________________________________
SPECIFICATIONS ______________________________________________________________
CLEARENCE DIMENSIONS ______________________________________________________
INSTALLATION REQUIREMENTS _________________________________________________
Electrical ___________________________________________________________________
ELECTRICAL CONNECTION _____________________________________________________
WIRING DIAGRAM _____________________________________________________________
INSTALLATION ________________________________________________________________
Unpackaging the rangetop_____________________________________________________
Installing the island trim _______________________________________________________
INSTALLATION CHECKLIST ______________________________________________________
FINAL PREPARATION ___________________________________________________________
BERTAZZONI SERVICE _________________________________________________________
USE ________________________________________________________________________
WARNINGS ____________________________________________________________________
WORKTOP AND KNOBS LAYOUT _________________________________________________
INDUCTION COOKTOP __________________________________________________________
KEEPING YOUR BERTAZZONI CLEAN _____________________________________________
TROUBLESHOOTING ___________________________________________________________
TWO YEARS LIMITED WARRANTY ________________________________________________
4
4
6
6
7
7
9
10
10
10
11
12
12
13
14
14
14
15
16
18
19
22
23
24

3
/ Models
Models
MAST365IRTXT
PROF365IRTXT
Models

4
/ Warnings
WARNINGS
To ensure proper and safe operation, the applian-
ce must be properly installed and grounded by a
qualified technician. DO NOT attempt to adjust,
repair, service, or replace any part of your applian-
ce unless it is specifically recommended in this
manual. All other servicing should be referred to
a qualified servicer.
FOR THE INSTALLER: Before installing the Ber-
tazzoni appliance, please read these instructions
carefully. This appliance shall be installed in ac-
cordance with the manufacturer’s installation in-
structions.
Important - Save these instructions for the local
electrical inspector’s use.
DO NOT remove permanently affixed labels, war-
nings, or plates from product. This may void the
warranty.
Installation must conform with all local codes. In
the absence of codes:
This rangetop is NOT designed for installation
in manufactured (mobile) homes or recreational
park trailers.
DO NOT install this range outdoors.
This appliance must be properly grounded.
Grounding reduces the risk of electric shock by
providing a safe pathway for electric current in the
event of a short circuit.
Warning!
To avoid risk of property damage, personal
injury or death; follow information in this ma-
nual exactly to prevent a fire or explosion.
WARNING!
If the information in these instructions is
not followed exactly, a fire or explosion may
result causing property damage, personal
injury or death.
- Do not store or use gasoline or other flammable
vapors and liquid in the vicinity of this or any
other appliance.
WARNING!
Never Operate the Top Surface Cooking
Section of this Appliance Unattended.
- Failure to follow this warning statement could
result in fire, explosion, or burn hazard that could
cause property damage. personal injury, or dea-
th.
- If a fire should occur, keep away from the
appliance and immediately call your fire depart-
ment.
DO NOT ATTEMPT TO EXTRINGUISH AN OIL/
GREASE FIRE WITH WATER
DANGER!!! ELECTRIC SHOCK HAZARD!!!
To avoid risk of electrical shock, personal injury
or death, verify that the appliance has been pro-
perly grounded in accordance with local codes or
in absence of codes, with the National Electrical
Code (NEC). ANSI/NFPA 70- latest edition.

5
/ Warnings
WARNING:
Cancer and Reproductiv Harm-
www.P65Warnings.ca.gov.

6
/ Data rating label / Before installation
The data rating label shows the model and serial
number of the rangetop. It is located under the
rangetop (see fig.) and on the cover page of this
manual.
• DO NOT remove permanently affixed labels,
warnings, or plates from product. This may
void the warranty.
• This appliance shall only be installed by an
authorized professional.
• This appliance shall be installed in accordance
with the manufacturer’s installation
instructions.
• This appliance must be installed in accordance
with the norms & standards of the country
where it will be installed.
• The appliance, when installed, must be
electrically grounded in accordance with local
codes or, in the absence of local codes, with
the National Electrical Code, ANSI/NFPA 70.
Room ventilation
An exhaust fan may be used with the appliance;
in each case it shall be installed in conformity
with the appropriate national and local standards.
Exhaust hood operation may affect other vented
appliances; in each case it shall be installed in
conformity with the appropriate national and local
standards.
Do not use aerosol sprays in the vicinity of
this appliance while it is in operation.
DATA RATING LABEL
void
the
warranty.
void the warranty.
void the warranty.
BEFORE INSTALLATION •data rating labels location

7
This rangetop will best perform when installed
with Bertazzoni exhaust hoods. These hoods
have been designed to work in conjunction with
the Bertazzoni range and have the same finish for
a perfect look.
Before installation of the exhaust hood, consult lo-
cal or regional building and installation codes for
additional specific clearance requirements.
Refer to the rangetop hood installation instructions
provided by the manufacturer for additional infor-
mation.
Select Hood and Blower Models:
• For wall installations, the hood should be
equal or larger width than the range. Where
space permits, a hood larger than the range
may be desirable for improved ventilation
performance.
• For island installations, the hood width should
overhang the range by a minimum of 3” (76
mm) on each side.
Hood Placement:
• For best removal of smoke and odors, the
lower edge of the hood should be installed
between 25 1/2” (65 cm) and 31 1/2” (80 cm)
above the range cooking surface.
• If the hood contains any combustible materials
(i.e. a wood covering), it must be installed at a
minimum of 36” (914 mm) above the cooking
surface.
Consider Make-Up Air:
Due to the high volume of ventilation air, a sour-
ce of outside replacement air is recommended.
This is particularly important for tightly sealed
and insulated homes. A qualified heating and
ventilating contractor should be consulted.
/ Ventilation preparation / Specifications
VENTILATION PREPARATION
SPECIFICATIONS
36"
25" 3/16
36"
7 5/8"
5 1/16" 1 9/16"
25 3/16"
22 3/4" 10 1/8"
1 3/4"

8
/ Specifications - Cabinet
Cabinet Preparation
1. To ensure professional results, the cabinet and
countertop openings should be prepared by a
qualified cabinet worker.
2. The clearances shown in figure are required.
3. The electrical supply must be located in an area
that is accessible without requiring removal of the
cooktop. The appliance electrical power cord is lo-
cated on the left rear.
• Prepare the finished opening for the rangetop
according to dimensions shown in the
illustration on the follows page.
• The platform must include a cut-out at the
right rear for electrical supply connection. It
must be level to ensure the cooking surface
is level. Refer to the chart below for minimum
base support.
BASE SUPPORT MIN
36” rangetop 250 lb (113 kg)
WARNING
To prevent possible damage to cabinets and ca-
binet finishes, use only materials and finishes that
will not discolor or delaminate and will withstand
temperatures up to 230°F (110°C). Heat resistant
adhesive must be used if the product is to be in-
stalled in laminated cabinetry. Check with your
builder or cabinet supplier to make sure that the
materials meet these requirements.

9
/ Clearence dimensions
CLEARENCES DIMENSIONS
Installation adjacent to kitchen cabinets
This range may be installed directly adjacent to
existing countertop high cabinets (36” or 91.5 cm
from the floor).
For the best look, the worktop should be level with
the cabinet countertop. This can be accomplished
by raising the unit using the adjustment spindles
on the legs.
ATTENTION: the rangetop CANNOT be installed
directly adjacent to kitchen walls, tall cabinets, tall
appliances, or other vertical surfaces above 36”
(91.4 cm) high. The minimum side clearance in
such cases is 6” (15.2 cm).
Wall cabinets with minimum side clearance must
be installed 18” (45.7 cm) above the countertop
with countertop height between 35 ½” (90.2 cm)
and 37 ¼” (94.6 cm). The maximum depth of wall
cabinets above the rangetop shall be 13” (33.0
cm).
Cabinet
A
B
B
C
D
E
F
G
L
36’ (91,5 cm) or 48” (122 cm)
30’’ (76,3 cm) hood with combustible materials
25’’ 1/2 (65 cm) hood with uncombustible materials
13’’ (33,0 cm)
18’’ (45,7 cm)
6’’ 5/8(16,8 cm)
6’ (15,2 cm)
min 3” 7/16 max 5” 3/16 (min 8,7cm max 13 cm)
25’’ 3/16(64 cm)
A
F
D
B
C
E
G
F
L

10
/ Installation requirements / Electrical connection
ELECTRICAL
A properly-grounded horizontally- mounted electri-
cal receptacle should be installed no higher than
27” (68.6 cm) above the floor, no less than 2” (5
cm) and no more than 15” (38,1 cm) from the left
side (facing product).
Check all local code requirements.
Warning!
ELECTRICAL SHOCK HAZARD
Disconnect electrical power at the circuit bre-
aker box or fuse box before installing the ap-
pliance.
Provide appropriate ground for the appliance.
Use copper conductors only.
Failure to follow these instructions could re-
sult in serious injury or death.
Warning!
Electrical grounding
This appliance is equipped with a 4 ft (1.2 m) flexi-
ble metal cable with 3 wires ready for connection
to a dedicated 2 pole, 3 wires grounded power
supply.
The appliance shall be connected to an electric
line rated at 208Vac or 240Vac and 60Hz frequen-
cy.
3 Wires connection:
-Connect the L1 receptacle terminal to the inco-
ming BLACK electrical supply wire (L1-hot wire)
-Connect the L2 receptacle terminal to the inco-
ming RED electrical supply wire (L2-hot wire)
-Connect the GROUND receptacle terminal to the
incoming GROUND (GREEN) electrical supply
wire
Caution
Label all wires prior to disconnecting when
servicing controls. Wiring errors can cause
improper and dangerous operation.
Verify proper operation after servicing.
INSTALLATION REQUIREMENTS ELECTRICAL CONNECTION
installation area for the connection
min 3" 7/16
max 5" 3/16
E
27"
15"
Voltage Appliance rating Electrical supply
208V
240V
10000W 44A
11500W 44A
50A
50A