Bestcare SA400H Instruction sheet

Congure Your SA400H/HE for First Use
Note: Model shown is SA400H

Step 1: Remove the base from box.
Step 2: Insert the mast and secure it using the bolt and
threaded knob as follows.
Step 3: Insert the boom to the mast and secure it using the
bolt and threaded knob as follows.

Step 4: Insert the lower end of the actuator (SA400HE) or the
hydraulic pump (SA400H) to the bracket on the mast and
secure it using a pin and retaining ring as follows.
Step 5: Insert the upper end of the actuator (SA400HE) or the
hydraulic pump (SA400H) to the bracket on the boom and
secure it using a pin and retaining ring as follows.
SA400HE
SA400HE
SA400H
SA400H

Step 6: Attach the footplate to the base using the two hooks
by lowering it onto the top surface of the base. Make sure
the hooks are sitting in between the two small blocks protruding
at the back of the base.
Step 7: Install the kneepad frame with the plastic U washer to
the kneepad. Choose one of the three holes on the tube
depending on the desired kneepad height. Then secure it using
bolt, nut and washers as follows.
Step 8: Pull the depth adjustment handle down and insert the
kneepad frame into the receiving tube located on the mast.
Release the handle and continue sliding the kneepad frame
until the handle clicks to ensure kneepad frame is locked in place.
Step 9: For SA400HE model, refer to “Quick Setup Guide to
TiMotion Electronics” to install the controller.