S-S-005919
2
Installation
Assembly can be completed without tools.
NOTE: It is important to assemble pool in the order shown below. Adult
assembly required.
AB
Fig. 1 Fig. 2
Fig. 3 Fig. 4
1. Find solid, level ground and clear it of debris.
Attention: Do not set up the pool under cables or under trees.
2. Spread out the pool and make sure it is right side up.
3. Cover the water valve.
4. Assemble the top rails. Connect Top Rail A to Top Rail B, and slide into
the pole sleeve (Fig.1). Please see the structure photo for detailed
directions. Make sure the top rails’ ends are in right position.
5. At the corners, insert the Top Rails (A & B) into the Corners (D).
Ensure the spring-loaded pins snap into the pre-drilled holes. (Fig. 2)
6.
Insert the Vertical Pool Legs (C) into the bottom of the Corners (D).(Fig. 3)
7.
Attach all Footings (E) to the bottom of the Vertical Pool Legs (C). (Fig. 4)
8.
Test the Frame to ensure all connections are secure before filling with water.
9. Put 1’’ to 2’’ (2 to 5cm) of water in the pool to the cover the floor. Once
pool floor is slightly covered, gently smooth out all wrinkles. Start in
the center of the pool and work your way clockwise to the outside.
10. Continue to fill the pool until reaches the water fill line located on the
pool’s interior. Please kindly pay the utmost attention not over fill the
pool for security reasons.
Dismantling
1. Open water valve on the bottom of the pool, water will drain
automatically. (Check local regulations for drainage by-laws). Then
dismantle the frame of the pool to release the water. Make sure release
most of the water in 20 minutes.
Note: Drain by adult only!
2. Air dry pool.
ATTENTION: Do not leave the drained pool outside.
Repair
If your pool is damaged, use the provided repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation.
Pool Maintenance
Warning: If you do not adhere to the maintenance guidelines covered
herein, your health might be at risk, especially that of your children.
1. Change the water of pools frequently (particularly in hot weather) or
when noticeably contaminated, unclean water is harmful to the user’s health.
2. Please contact your local retailer to obtain chemicals to treat the water
in your pool. Be sure to follow the chemical manufacturer’s instructions.
3. Proper maintenance can maximize the life of your pool.
4. See packaging for water capacity.
Cleaning and Storage
1. After deflation, use a damp cloth to gently clean all surfaces.
Note: Never use solvents or other chemicals that may damage the
product.
2. Remove all the accessories and spare parts of the pool and store them
clean and dry.
3. Once pool is completely dry, sprinkle with talcum powder to prevent
pool from sticking together, fold pool carefully. If pool is not completely
dry, mould may result and will damage the pool liner.
4. Store liner and accessories in a cool, dry place out of children’s reach,
with a moderate temperature between 5°C / 41°F and 38°C / 100°F.
5. During the rainy season, pool and accessories should be stored as
instructed above.
6. Unproper draining of the pool might cause serious personal injury
and/or damage to personal property.
7. Check the product for damage at the beginning of each season and at
regular intervals when in use.
