Betafence Quixolid Plus User manual

Quixolid ® Plus
Installation manual EN
28-10-2019

YOU TUBE
• A detailed installation video can also be found online on YOUTUBE

0. Content
1. Components of the fencing system
1. The posts
2. The Nylofor panels
2. Installation of the fencing system
1. Foundations
2. Install posts & panels

1. Components of the fencing system
1. The posts
-Profile 75x50x1mm (steel S 350)
-Post without accessories
-Posts are available for panels heights from 0.6 to 2.4 metres
-The posts are galvanised inside and outside and polyester-
coated afterwards
-This type of post can be installed with all Bekafor / Nylofor 3D
panel types, all Nyl 2D / 2DS / F panels
-Each post is fitted with a polyamide post cap
-A base plate / bent arm can be screwed onto the post
-Holes to connect the base plate are standard foreseen in the
post
-Corners can be made with a standard post

2. Installation of the fencing system
1. Foundations
-To obtain the best result, it is advisable to level the ground over the whole length of the fence
-For correct positioning, maintain the centre-centre distances. The distance is determined by the
type of panel being installed
-Align the fence line
-To determine the dimensions of the foundations it is advisable to consult a specialised engineer to
evaluate wind load and solar conditions and any other factors requiring specialist opinion
(concrete quality directive B30)
Panel width Post system Centre-centre distance
2000 Quixolid PLUS 2040 mm
2500 Quixolid PLUS 2540 mm
3000 Quixolid PLUS 3040 mm
Example:

2. Installation of the fencing system
2. Installation posts & panels
-Installation principle: Quixolid PLUS posts are installed according to the ‘post-panel-post’ system
-(1) Bring the panel into the “bounding box” of the post
-(2) Push to the panel towards the end of the post
-(3) Move the panel in the right direction untill it blocks safely behind the lips of the posts
3
STEP 1 STEP 2 STEP 3

2. Installation of the fencing system
2. Installation posts & panels
-The panel is directly secured by the inner folding that
blocks the vertical wire of the panel
-Use the tension tool to keep the panels in position while
installing the fence

2. Installation of the fencing system
2. Installation posts & panels
MAKING CORNERS
Corners between 60° and 180° can be made with one and the same post

2. Installation of the fencing system
2. Installation posts & panels
INSTALLATION ON SLOPES
Slopes are possible per steps of 100mm

2. Installation posts & panels
INSTALLATION OF THE BASE PLATE
- Holes are already foreseen in the posts
2. Installation of the fencing system
Screw M8x20 – stainless steel - 2x
M8 washer - stainless steel - 4x
M8 nut - stainless steel - 2x
Note: bolts and washers are not included
with the footplate