Betafence Securifor 2D User manual

Securing What Matters
Securifor on
Bekafix Super posts
Installation manual
Patent
pending
concept

2datum-titel
Securifor on Bekafix Super posts
1. Installing the posts
3. Align the posts vertically and fix position
with concrete
1. Define interdistance with wooden template.
Attach a fixator on every post to hold the
template in position
Center-center distance of posts
=2545mm (+/- 2mm)
All posts are installed before attaching the panels!
(This installation is with flat Securifor panels. For 2D &3D Securifor panels, new spider fixators are needed.)
2. Align horizontally, to check if the posts are at
the same height
Remark: it is better to take the maximum distance between the
posts and adjust the difference when attaching the panels with
spider fixators to the posts

3datum-titel
Securifor on Bekafix Super posts
2. Installing the panels
1. The panel should be bowed slightly to fit
between the posts
Spider fixators are fixed with Mushroom Head Squareneck
bolts M6(DIN 603) with washer and self-breaking nut
2. Fix the panel with 2 fixators to the first
post

4datum-titel
Securifor on Bekafix Super posts
2. Installing the panels
3. Fix the panel with 2 fixators to the second
post. Put a spider fixator at only one side of the
post (at the side of the panel)
4. Attach all the fixators on the first post
6. Fix the 2nd panel to the second post with one
fixator in the middle (use a free hole)
7. Attach the panel to the third post with two
fixators at one side
5. Install the second panel
Remark: with Securifor panels it’s not possible to use the hook of the
post cap to hang up the panel →fix a spider fixator in a free hole in
the middle of the post

5datum-titel
Securifor on Bekafix Super posts
2. Installing the panels
8. Align the panel and fix all the
fixators on the second post (take
away the middle fixator)
9. Repeat these steps to install all
the panels

6datum-titel
Securifor on Bekafix Super posts
3. Remarks
→After installation, it’s necessary to install a U-profile
on the top of the panels to make sure you have a
perfectly flat installation!
→For the installation of flat Securifor on Bekafix Super posts,
the installer can drill an extra hole on top of the post to be
able to fix an extra fixator, to avoid folding the top of the
panel

7datum-titel
Securifor on Bekafix Super posts
3. Remarks
To get a higher rigidity of the panel, it is advised to also add a fixation at the bottom.
There are 3 possible ways:
1. A short H-profile that’s sliding over a concrete plate and can be
fixed to the Securifor panel
(fixed with bolt M8x25 DIN603, washer and self-breaking nut M8)
2. An L-profile that’s fixed to the bottom of the panel
For extra security, this profile can also be fixed to a concrete
foundation
(fixed with bolts M8x25 DIN7380, large washer M8x30x1.5 at the
front, washer and self-breaking nut M8 at the back)
3. Or put the 3 bottom horizontal wires of the Securifor panel into the
concrete or soil