Better Homes and Gardens Collin BH16-084-399-03 User manual

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Date 2017-04-28 Rev. 0001-B Factory: NICFUR
Collin 2pk Dining Chair
Stock # BH16-084-399-03 White
# BH16-084-399-04 Green
# BH16-084-399-05 Silver
ADULT ASSEMBLY REQUIRED
If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the
store where it was purchased. Please call our customer service number and have your instructions
and parts list ready to provide the model name, part name or factory number:
866-942-5362
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday - Friday
Or visit our web site 24 hours a day, 7 days a week for product assistance at
www.whalenstyle.com
Or e-mail your request to [e-mail]
LOT NUMBER:
DATE PURCHASED: / /

2
1. Maximum load weight 136 kg (300 pounds).
1. Please read the Assembly Instructions prior to assembling the unit.
2. To avoid damage, assemble the unit on a sturdy, level and non-abrasive surface.
3. Keep all hardware and parts out of reach of children.
4. Please wait until all steps are completed before fully tightening bolts.
5. Make sure all bolts are tightly fastened before the unit is used.
6. Check that all bolts, screws and knobs are tight at least every 3 months or as needed.
GENERAL INFORMATION, TIPS & TRICKS
MAXIMUM RECOMMENDED WEIGHT LOADS
THIS UNIT IS INTENDED ONLY FOR USE WITHIN THE MAXIMUM
WEIGHTS INDICATED. USE WITH LOAD HEAVIER THAN THE MAXIMUM WEIGHTS
INDICATED MAY RESULT IN INSTABILITY, CAUSING POSSIBLE INJURY.

3
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware are present
before beginning assembly.
A- Chair Backrest (Qty. 2) B- Seat (Qty. 2)
C- Metal Stretcher (Qty. 2) D- Front Leg (Qty. 4)
(1) 1/4" x 5/8" Bolt 4 mm Hex Wrench
(Qty. 20+1 extra) (Qty. 1)
Tools required: Hex wrench (provided).

4
Assembly Instructions
1. Unpack the unit and confirm that you have all the hardware and required parts.
2. Lay one Backrest (A) on a smooth and protective surface with the threaded sockets facing up.
3. Attach one Seat (B) to the Backrest (A) with four 5/8" Bolts (1). DO NOT fully tighten the bolts.
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
1
A
B
1/4" x 5/8" Bolt
(4 used in this step)
①

5
Assembly Instructions
4. Fasten one Metal Stretcher (C) to the Backrest (A) with two 5/8" Bolts (1).
11
A
C
1/4" x 5/8" Bolt
(2 used in this step)
①