Bhevs WC500MNM Instruction Manual

Wireless charger Unit
Type 2 : Located in front of arm rest
Type 3 : Located in center dashboard
Type 1 : Located in arm rest
1
Installation & User manual
1. Put your phone on wireless charging pad directly and on the center of charging pad.
2. Check the phone if it was charged or not. you can check on the mobile phone screen
If the phone was not charged, please try to put your phone on the charging area again.
Device Type : Wireless Power charger
Model Type : WC500M-NM
Manufacturer : LG Electronics Inc.
Dimension: 136(L) x 95(W) x 22.5(H) mm
Support WPC(Qi) 15W •Mainly this wireless charging unit can be used for wireless charging mobile phone.
•Also can charge all devices meet WPC(Qi) standards

2
FCC, IC Compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacturer (or party responsible) for compliance could void the user’s authority to operate the equipment
FCC RF Radiation Exposure Statement: This equipment complies with FCC RF Radiation exposure limits set forth for an uncontrolled environment. This device and its
antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance of 15 cm between the radiator and your body.
IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 15 cm between the radiator & your body.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
This device contains licence-exempt transmitter(s)/receiver that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions:
1.This device may not cause interference.
2.This device must accept any interference, including interference that may cause undesired operation of the device.
Avis d’Industrie Canada sur l’exposition aux rayonnements
Cet appareilest conforme aux limites d’exposition aux rayonnementsd’Industrie Canada pour un environment non controle. Il doitetreinstalle de facona garder une distance
minimale de 15 centimetres entre la source de rayonnements et votrecorps.
REMARQUE: LE FABRICANT N'EST PAS RESPONSABLE DES INTERFERENCES RADIOELECTRIQUES CAUSEES PAR DES MODIFICATIONS NON AUTORISEES
APPORTEES A CET APPAREIL. DE TELLES MODIFICATIONS POURRAIT ANNULER L'AUTORISATION ACCORDEE A L’UTILISATEUR DE FAIRE FONCTIONNER
L'APPAREIL.
Cet appareilcontient des emetteurs / recepteursexempts de licence qui sontconformes aux RSS exempts de licence d'Innovation, Sciences et Developpement economique
Canada.
L’exploitation est autorisee aux deuxconditions suivantes:
1.L’appareil ne doit pas produire de brouillage;
2.L’appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d’en compromettre le fonctionnement.