Big Lots GB19-510 User manual

OAKMONT CHAISE LOUNGER WITH CUSHION
ASSEMBLY INSTRUCTION
ITEM# GB19-510 / GB19-510-NAVY
SKU# 4810414474 / 810460265
CARE & MAINTENANCE
DO NOT RETURN THIS PRODUCT TO THE STORE. FOR MISSING PARTS OR QUESTIONS TO THIS PRODUCT PLEASE CALL US AT 1-888-733-8169 OR
EMAIL US AT [e-mail] OR [e-mail] OR [e-mail]
IMPORTANT:
Please read all the instructions and warnings before assembling. In order to make the whole product adjust to the best, please install all the screws on the product before
fully tighten, and note to put the washer to the screw before putting the screw into the screw hole.
WARNING:
Use the correct screws as indicated. All screws should be hand tight untill the complete piece is assembled ( This will make the assembly process
much easier ). Once the piece is fully assembled, then go back and tight all screws with provided tool.
STAIN RESISTANT CUSHIONS CARE —— KEEP THE CUSHIONS IN STORAGE IN RAINING DAY.
SPILLS: Immediately wipe up the spill using a white damp cloth. Repeat process if necessary until stain is gone. Allow cushion to air dry.
FABRIC CARE: Hand wash cold, non-chlorine bleach when needed, lay flat to dry. Cool iron if necessary. Do not dry clean.
ALL WEAHTER WICKER PRODUCT CARE
Before using, clean the product completely with a soft dry towel. When not in use, wipe free of any dirt or loose objects, wash with a mild solution of soap and water,
rinse thoroughly and dry completely. Do not use strong detergent or abrasive cleaners. Over time nuts and screws can loosen. Occasinally, check nuts and screws on the
lounger, re-tighten if necessary.
Keep all children and pets away from assembly area. Children and pets should be supervised when they are in the area of the product construction.
Keep assembly area at leat 6 feet from any obstruction such as a fence, garage, house, overhanging branches, laundry line or electrical wires.
Some parts may contain sharp edges. When assembling and using this product, basic safety precautions should always be followed to reduce the risk of personal injury
and damage to the product. Please read all instructions before assembly and use.
The lounger is for sitting purpose only, is not to be used for standing purposes and will not function as a stool or step-ladder. Use on even surfaces only.
The lounger is not a toy. Lounger tested for use at weight of 250 lb (113.4kg). Improper use of this product or failure to use as directed may
result in injury. Not intended for commercial use.

NO. Part Qty Image NO. Part Qty Image
A1Right Arm B1Left Arm
C1Seat Panel D1Back
E1Skirt Panel F10 Short Screw
G4Long Screw H2Nut
I14 Washer J1Allen Wrench
PARTS LIST
STEP 1 STEP 2
DO NOT TIGHTEN ALL SCREWS NOW. DO NOT TIGHTEN ALL SCREWS NOW.
STEP 3 STEP 4
DO NOT TIGHTEN ALL SCREWS NOW. VERIFY THE ALIGNMENT AND ADJUST, FULLY TIGHTEN
ALL SCREWS. PUT ON THE CUSHION AND FINISH THE
ASSEMBLY.