Big Lots SW-RK1114 User manual

50 IN STEEL PARK BENCH
ASSEMBLY INSTRUCTION
ITEM# SW-RK1114
SKU# 810503338
DO NOT RETURN THIS PRODUCT TO THE STORE. FOR MISSING PARTS OR QUESTIONS TO THIS PRODUCT PLEASE CALL US AT 1-888-733-8169
OR EMAIL US AT customerservice [e-mail] OR customerservice [e-mail] OR customerservice [e-mail]
IMPORTANT :
Please read all the instructions and warnings before assembling . In order to make the whole product adjust to the best, please install all the screws on the product
before fully tighten, and note to put the washer to the screw before putting the screw into the screw hole.
WARNING :
Use the correct screws as indicated. All screws should be hand tighten until the complete piece is assembled ( This will make the
assembly process much easier ). Once the piece is fully assembled, then go back and tighten all screws with provided tool.
Keep all children and pets away from assembly area. Children and pets should be supervised when they are in the area of the product construction .
Keep assembly area at leat 6 feet from any obstruction such as a fence, garage, house, overhanging branches, laundry line or electrical wires.
Some parts may contain sharp edges. When assembling and using this product, basic safety precautions should always be followed to reduce the risk of personal
injury and damage to the product. Please read all instructions before assembly and use.
The bench is for sitting purpose only, is not to be used for standing purposes and will not function as a stool or step-ladder. Use on even surfaces only.
The bench is not a toy. Bench tested for use at weight of 350 lb (159 kg). Improper use of this product or failure to use as directed may
result in injury. Not intended for commercial use.
CARE & MAINTENANCE
Before using, clean the product completely with a soft dry towel. When not in use, wipe free of any dirt or loose objects, wash with a mild solution of soap
and water, rinse thoroughly and dry completely . Do not use strong detergent or abrasive cleaners. Screws can be loosen over a peirod of usage, please
check the screws occasionally and re-tighten if necessary.

PARTS LIST
NO. Part Qty Image NO. Part Qty Image
ABench Right Arm 1FLong Screw
（M6*55mm）4
BBench Left Arm 1GWasher 8
CBench Seat Panel 1HNut 4
DBench Back Panel 1IWrench 1
EShort Screw
（M6*50mm）4
STEP 1 STEP 2
Secure Bench Seat Panel (C) to Left arm (B) and Right arm (A) with 4
Short Screw (E), 4 Washer (G) and 4 Nut (H) by using Wrench (I) . Do
not tighten all screws now.
Secure Bench Back Panel (D) to Left arm (B) and Right arm (A) with
4 Long Screw (F) and 4 Washer (G) by using Wrench (I) . Do not
tighten all screws now.
STEP 3
Verify the alignment and adjust, fully tighten all screws.