Biltema 82-720 User manual

© 2011-10-10 Biltema Nordic Services AB © 2011-10-10 Biltema Nordic Services AB
Helmet
it is imPortant tHat
YoU reaD tHe User manUal
anD all WarninG laBels.
Art. 82-720, 82-721, 82-722, 82-723,
82-726, 82-727, 82-728, 82-729, 82-730,
82-736, 82-737, 82-738, 82-739, 82-740
1200 g (+/-50 g)
ECE
ECE 22:05 Carbonmix
Carbonmix
Quick release
sUGGestions for PUrcHase
1. Choosing the size: Choose your own helmet by
measuring the circumference of your head with a
exible tape measure.
2. Restriction: Make sure that the helmet doesn’t
restrict your movements, for example, when you turn
your head to look behind you.
3. Comfort: Only wear a comfortable helmet and
when you are not suffering from headaches or
sickness.
4. Adherence: Make sure that the helmet doesn’t
move around when the retention system is open.
5. Homologation: Make sure that the helmet has a
sticker which certies the homologation.
14

© 2011-10-10 Biltema Nordic Services AB © 2011-10-10 Biltema Nordic Services AB
User manUal
Please read the following information before using a
new helmet.
Basic information
The helmet is produced according to the newest
technology and is specically designed for motorcy-
clists. Using a helmet dose not exclude all possibi-
lity of injury, in some instances impact may be too
high to protect the user effectively from fatal head
injuries.
instrUctions for Use
1. Invisibility: Ensure that the visor is clean and
seamless at all times, never use a smoky visor at
night or visibility will be poor. Exchange a damaged
visor for a genuine replacement immediately.
2. No modification: Never make any changes to any
part of the helmet. Don’t make any alterations to the
outer shell, don’t insert screws and most importantly
don’t apply paint. Keep us informed if you would like
to paint the helmet.
3. Care and cleaning: When cleaning the shell and
interior of the helmet, never use solvents, petrol and
other detergents. Only use water and PH balanced
soap. Use soap and a small brush to clean the pad
and the visor. Leave the visor to air-dry. Don’t ex-
pose the visor to any sources of heat.
4. Retention system: The retention system has to
be carefully set and locked always.
5. Scarves: Never wear scarves and other headgear
underneath the retention system. Always ensure that
there is no airow restriction inside the helmet.
6. Spare parts: Only use the original spare for the
helmet.
7. Inspections replacement: The helmet is desig-
ned to absorb the energy of a blow and a collision by
destroying some of its components. In the event of
a further blow, it will not protect you any longer, so it
must be replaced even though it doesn’t show any
external damage.
32