Castles Technology SATURN1000MINI User manual

SATURN1000MINI POS Terminal
Book 2
User Manual
S1MINI
Confidential
Version 1.0
Dec. 2022
CRT-S1-11-02-V1.0-CE-FCC-IC-CB-UL-cUL
CASTLES TECHNOLOGY
Castles Technology Co., Ltd.
6F, No. 207-5, Sec. 3, Beixin Rd., Xindian District,
New Taipei City 23143, Taiwan R.O.C.
http://www.castech.com.tw

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 2
WARNING
Information in this document is subject to change without prior notice.
No part of this publication may be reproduced, transmitted, stored in a retrieval system,
nor translated into any human or computer language, in any form or by any means,
electronic, mechanical, magnetic, optical, chemical, manual, or otherwise, without the
prior written permission of Castles Technology Co., Ltd.
All trademarks mentioned are proprietary to their respective owners.

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 3
Revision History
Version
Date
Descriptions
Author
1.0
2022.12.27
Initial creation.
Dustin

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 4
Contents
1. Introduction..................................................................................................................5
2. Hardware Setup............................................................................................................6
2.1. Parts of the Terminal ...........................................................................................6
2.2. Insert Battery.......................................................................................................8
2.3. Insert SAM Card..................................................................................................9
2.4. Insert GSM Micro SIM Card...............................................................................10
3. Appendix ....................................................................................................................11
3.1. FCC...................................................................................................................11
3.2. IC.......................................................................................................................12
3.3. UL / IEC 62368-1...............................................................................................13

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 5
1.Introduction
This document provides a guideline for operating and configuring Castles S1 MINI terminal.
The scope of this document includes setting up the terminal, basic operation, application
lifecycle, and some advanced features.
Regulatory instruction of usage
●Before using the terminal, please check the does it has been disassembled, modified,
or happened the abnormal situation. If yes, please do not continue to use.
●Please stay away from strong electromagnetic waves.
(Example) Microwave ovens, magnets, shoplifting prevention devices, high-voltage
wires, automatic doors, communication antennas, etc.
●Condensation can occur when moving from a cold place to a warm place. If
condensation occurs, do not use the unit until the connected water droplets evaporate.
●Static electricity may occur in some places (such as where you are using a carpet).
●Please do not leave it in the sun for a long time.
●Please operate the unit carefully as it is a precision instrument. Do not apply impact,
drop or heavy objects on top of the unit.
●Do not attach dust, oil, etc. to a part of the power terminal. Also, please do not scratch.

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 6
2.Hardware Setup
2.1. Parts of the Terminal
Front
1. Camera
2. Contactless Card Landing Zone
3. LCD Display
4. Smart Card Reader
1
2
3
4

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 7
Rear
5. Product Label
6. Charger Pin
7. Rechargeable Battery Cover
8. GSM Micro SIM Card Slot
9. SAM Card Slots
Left side Right side
10. USB Type C Slot
11. Power Button / LED Indicator
Green Light: External power source connecting and battery is full.
Red Light: Battery charging function activated
8
5
7
6
11
10
Rechargeable
Battery
9

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 8
2.2. Insert Battery
Step 1: Remove the battery cover.
Step 2: Insert the battery into the compartment.
Step 3: Reverse the operation of step 1 to install the battery cover.
Note:
1. Please confirm the battery is installed before power on the terminal.
2. Highest specified charging temperature: 45±3°C; Lowest specified
charging temperature: 0±3°C.
Step 2
Step 1

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 9
2.3. Insert SAM Card
Step 1: Remove battery cover / back cover
Step 2: Insert SAM card into desire slot.
SAM
Gold contact is on the upper side of the card and facing down.
Step 3: Reverse the operation of step 1 to install the battery cover.
SAM

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 10
2.4. Insert GSM Micro SIM Card
Step 1: Remove battery cover / back cover
Step 2: Insert GSM Micro SIM card into desire slot.
SIM:
Cut corner is on the upper left side of card and facing down.
Step 3: Reverse the operation of step 1 to install the battery cover.
SIM

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 11
3.Appendix
3.1. FCC
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Radiation Exposure Statement:
The product complies with the FCC portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual. The further RF
exposure reduction can be achieved if the product can be kept as far as possible from the
user body or set the device to lower output power if such function is available.
Note: The country code selection is for non-US model only and is not available to all US
model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation
channels only.

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 12
3.2. IC
Industry Canada statement
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne
doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage
reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.
Caution :
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce
the potential for harmful interference to co-channel mobile satellite systems;
Avertissement:
(i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement
pour une utilisation à l’intérieur afin de réduire les risques de brouillage
Radiation Exposure Statement:
The product complies with the Canada portable RF exposure limit set forth for an
uncontrolled environment and are safe for intended operation as described in this manual.
The further RF exposure reduction can be achieved if the product can be kept as far as
possible from the user body or set the device to lower output power if such function is
available.
Déclaration d'exposition aux radiations:
Le produit est conforme aux limites d'exposition pour les appareils portables RF pour les
Etats-Unis et le Canada établies pour un environnement non contrôlé.
Le produit est sûr pour un fonctionnement tel que décrit dans ce manuel. La réduction aux
expositions RF peut être augmentée si l'appareil peut être conservé aussi loin que possible
du corps de l'utilisateur ou que le dispositif est réglé sur la puissance de sortie la plus faible
si une telle fonction est disponible.

Castles Technology Co., Ltd. Confidential • All Right Reserved. Pg. 13
3.3. UL / IEC 62368-1
Warning:
Power cord shall be connected to a socket-outlet with earthing connection.
Warning:
Risk of explosion if battery is replaced by an incorrect type. Dispose of expended
battery in accordance with local disposal regulations.
Warning:
This product is intended to be supplied by a Listed Power Adapter "L.P.S." (Or
"Limited Power Source") and is rated at 5 Vdc, 2 A min., Tma = 40 degrees C.
●Attention:
le cordon d'alimentation doit être branché sur une prise secteur avec mise à la
terre.
●Attention:
Risque d'explosion si la batterie est remplacée par une de type incorrect Éliminer
la pile usagée conformément à la réglementation locale en vigueur.
●Attention:
Le produit est destiné à être alimenté par un adaptateur secteur répertorié «
L.P.S. » (ou "Source d'alimentation limitée") et est évalué à 5 Vdc, 2 A min., Tma
= 40 degrés C.
~ END ~