BioDerm Men's Liberty BioPlus+ User manual

Men’s LibertyTM Instructions for Use
BioPlus+TM Prep Wipe
FreeDermTM
Adhesive Remover
Men’s LibertyTM
External Catheter
a) Familiarize yourself with the products to the
right and review the application instructions
(see reverse side) before applying.
b) Make sure you have a non-moisturizing
bar soap like Ivory or Gold Dial at home -
do not use liquid soap.
c) Consider using a Kind KlampTM if you think
you may experience leaking during
application, you are uncircumcised
or have retraction.
Call [phone]
to place an order.
d) Watch the application instruction
video at mensliberty.com
1Review Contents
Follow these steps for proper application:
Bioderm, Inc.
12320 73rd Court North
Largo, FL 33773, USA
Orders: [phone]
Support: [phone]
[e-mail]
www.MensLiberty.com
EC REP
©2017 BioDerm, Inc. All rights reserved. BioDerm® is a registered trademark
of BioDerm, Inc. Men’s Liberty™, FreeDerm™, BioPlus+™ and KindKlamp™
are trademarks of BioDerm, Inc. Men’s Liberty US patent #8,551,062
NOT MADE
WITH NATURAL
RUBBER LATEX
Authorized
Representative:
Advena Ltd.
Pure Oces, Plato Close,
Warwick, CV34 6WE, UK
Nurse Support Line: [phone]
Hours: Mon-Fri, 9:00am-5:00pm EST
Preparation
Removal
Application
Kind KlampTM
Penile Clamp
Optional Leak Prevention
LT 90145 Q
PART# 23046
Men’s LibertyTM
Faceplate Strip

2Wash & Dry
Begin by washing the head of the penis with a
non-moisturizing bar soap like Ivory® or Gold Dial®.
Allow skin to dry completely. Use a Kind Klamp to prevent
leaking during washing if necessary. Dry thoroughly.
3Pre-Application Prep
Wipe the head of the penis with BioPlus+TM wipe. Allow
15-20 seconds to dry until the skin is no longer tacky.
4Positioning & Application
Position Men’s Liberty so that the vent is facing up. Align
the vent with your urinary opening. Remove release
papers around the petals and attach the faceplate to the
tip of the penis with the center opening directly in line
with the urinary opening. Smooth down petals.
5Secure and Seal
Apply the faceplate strip around the head of the
penis, flat and wrinkle free. Be sure the adhesive
material is pressed into all of the ridges and grooves
in the skin. Press and hold for 10-15 seconds to
secure the seal.
As a result of using diapers or condom
catheters, your skin may have a lot of
moisture. Men’s Liberty will soak up extra
moisture until your skin returns to a normal
balance. It can take up to three consecutive
applications for you to get a full 24-Hour
wear time. Always reapply another Men’s
Liberty right away if one falls o. It may take
up to a full week of wear-time until you are
comfortable wearing Men’s Liberty.
Your First Few Days
For Overnight Use
Unplug the bottom of the Men’s Liberty pouch and connect
your bedside bag. Hang the bed bag from your bed frame or
rest against the floor. Keep below the bladder or bed to ensure
drainage. Do not twist or kink the tube.
Call [phone] to order
6Removal
FreeDermTM is recommended to remove Men’s Liberty. Men’s
Liberty can also be removed by soaking the seal with warm water
or a wet washcloth until it is milky white and rolls gently from the
skin. TO USE: Spray the edge of the adhesive, lifting gently from
the skin as you go. Continue to spray under the adhesive until
completely removed. Never pull or tear from the skin.
Men’s LibertyTM Instructions for Use
Nurse Support Line: [phone]
Hours: Mon-Fri, 9:00am-5:00pm EST
LT 90145 Q
PART# 23046
!
Vent