Bionaire B435BR User manual

+f!r--- -..
.--~_~_--.-
_-_
.
.-
--.
BlrINAlRE’
Fan Heater
B435BR
OWNER’S MANUAL
LIVRET D’INSTRUCTIONS
BETRIEBSANLEITUNG
MANUAL DE INSTRUCCIONES
INSTRU@ES DE OPERA@0
MANUALE DEL PROPRIETARIO
GEBRUIKSAANWIJZING
BRUKANVISNING
KAYTTOOHJEET
BRUKER MANUAL
BRUGERVEJLEDNING
Instrukcja obstugi
KULLANMA KILAVUZU
OAHTIEI: XPtiIERI
PYKOBOfiCTBO II0 3KCILJWATAQEH

- ---- -
-::
-+--i-J!
B435BR
fig. 2

ENGLISH
CONGRATULATIONS!
You have just acquired one of the finest heaters on the market today.
This heater has been designed using the latest in technology. With normal
care and maintenance, your Bionaire” Fan Heater will provide years of
satisfactory performance.
READ AND RETAIN THE FOLLOWING FOR FUTURE REFERENCE.
Note: Before reading these instructions, please unfold the back page for the
corresponding illustrations.
GENERAL DESCRIPTION
A) Air Inlet Opening
B) Air Outlet Opening
C) Mode control
D) Thermostat
E) Carry handle (not shown)
F) Cord wrap (not shown)
G) Power light
H) Heat Logic (Timer)
IMPORTANT SAFEGUARDS
l Before connecting the appliance, check that the voltage indicated on the rating
plate corresponds to the mains voltage in your home/office.
9 Read these instructions carefully, in conjunction with the illustrations before
using the appliance.
l When using electrical appliances, basic precautions should ALWAYS be taken
to reduce the risk of fire, electric shock or injury to persons.
l The appliance is double insulated and need not to be connected to an earthed
mains outlet.
. Avoid the use of an extension cord because the extension cord may overheat
and cause a risk of fire.
l If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent in order to avoid hazard.
l Allow a safe area around the heater away from furniture or other objects:
at least 50 cm from the top and sides and 120 cm at the front.
l Do NOT use the heater in rooms with explosive gas (e.g. petrol) or while using
inflammable glue or solvent (e.g. when gluing or varnishing parquet floors,
PVC etc)
.
Extra caution is necessary when the heater is used near children or whenever
it is left unattended.
l Do NOT insert any objects into the heater.
. Attention: this heater is hot when in use.
.
Keep the main cord at a safe distance from the inlet and outlet openings.
.
Prevent overheating of the appliance by keeping the air inlet and outlet openings
free: do NOT hang anything in front of it or above it. Check the openings from
time to time for accumulated dust. If overheating should occur, the built-in
overheating safety device will switch off the appliance.
4

-i--‘-’
_x____--I.----~
-~
---
ENGLISH
l Do NOT use aerosols, inflammable substances or materials sensitive to heat to
be in the flow of hot air.
SAFE POSITIONING
l Do NOT use this heater outdoors.
lIf the heater is going to be used in a bathroom, it must be installed:
- in such way that switches and other controls cannot be touched by
the person in the bath or shower;
- outside the grey shadowed areas (fig. 1 and 2)
lThe appliance must NOT be covered - otherwise there is risk of fire.
lPosition the appliance in such a manner that the airflow, towards the heater
and away from it, is NOT obstructed.
lSelect a spot to avoid electrical shock and the risk of fire.
WALL MOUNT INSTRUCTIONS
(see fig. 3 & 4)
In order to attach the appliance to the wall, use the wall mount bracket kit included.
1. Position the bracket as show on figure 3. Level the bracket for best installation.
2. Use the bracket holes as a pattern to mark the drilling holes for fastening.
3. Drill the holes and secure the bracket to the wall.
4. Carefully turn the unit to a horizontal position. With the back of the unit facing
the already secured bracket, insert the T-shaped fastener on the back of the
heater into the slot on the bracket. Once inside the slot, carefully rotate the
heater to the upright, vertical position.
OPERATING INSTRUCTIONS
lRemove the heater from the packaging and place it in the desired location.
lUnwind the power cord and plug the power supply cord into a convenient
electrical outlet. When the unit is plugged in for the first time, the display will
flash 12:OO on and off. In order to set the current day time, press the hour and
minute buttons accordingly, until you have reached the correct time.
Note: The clock has the option for a battery back up to maintain the time even
if the heater is unplugged. (Two “AA” batteries not included).
l To activate the heater, press the power button once and the display will switch
from the day time to read FAN. The fan will be activated and the power light
will be lit. Push the power button for the second time and it will switch to the
maximum heat power (2000W). If you depress the button for the third time the
unit will be turned off.
THERMOSTAT INSTRUCTIONS
This heater offers the possibility to regulate the temperature to the precise degree.
By turning the thermostat knob on the right side of the heater the display will change
from the current daytime into indicating the temperature. By turning the knob
clockwise, the temperature can be changed by degree. Three (3) seconds after
you have stopped turning the knob and selected the temperature, the current daytime
will be displayed and the thermostat will automatically keep your comfort level.

ENGLISH
TIMER (Heat Logic)
This heater is equipped with a timer. You can set the timer as follows:
lDepress the SET button and the displayed current day time will be switched to
a flashing 1:OO.
lSet the time you want the heater to turn on by pressing the hour and minute
buttons. After 3 seconds of displaying the preset time, the display will switch
back to the current day time.
l The function is not active until you press the Heat Logic button. To indicate
that the timer has been activated, a red light will be lit in the display screen.
This light will remain lit as long as the heater is in the Heat Logic mode. As
soon as the heater has operated in the Heat Logic mode the flashing red light
will be turned off. To reactivate the timer for the next day, press the Heat Logic
button again.
. The heater can be set to operate for a specific amount of time. To activate this
function: press the SET button for three (3) seconds and the number 60 will
appear on the display screen indicating the amount of minutes the heater is
set to operate. By pressing the SET button you have the option to set 60, 45,
30 and 15 minutes. Release the button and after three (3) seconds the display
will return to the current daytime.
Note: This feature is only available when the Heat Logic mode is activated.
AUTO SAFETY SHUT OFF
The heater has a built in safety device, which will switch of the heater in case of
accidental overheating. To reset the heater, follow the next steps:
I. Turn the control setting to the (OFF) position.
2. Unplug the heater and wait for 5 - IO minutes for the unit to cool down
3. After the 5 - IO minutes plug the unit in again and operate normally.
CLEANING AND MAINTENANCE
. Turn the knob to the (OFF) position.
. Remove the plug from the wall socket.
l Wait for the heater to cool down sufficiently.
lYou may clean the outside of the heater with a damp cloth. Do NOT allow
water to come into the appliance. Do NOT use soap or chemicals, which may
damage the housing. Allow sufficient time to dry before plugging the unit back
in the socket.
lClean the air inlet and outlet openings regularly (with normal use at least twice
a year) with a vacuum cleaner.
STORAGE TIPS
If you do not plan to use your heater for an extended period of time (i.e. during
the summer months), we recommend you to re-pack the unit in its original
packaging or any other dust-free packaging and store it in a dry and COOI place.

ENGLISH
SERVICE
Should your unit require service, please contact your local dealer.
A proof of purchase will be required by the service center for all warranty claims.
Dimensions:
Weight:
Power supply cord:
Heat settings:
Input voltage:
TECHNICAL SPECIFICATIONS
23 (L) x 14 (W) x 29 (H) cm
1.2 kg
2 pin, round plug
2 (plus cool setting)
220-24OV- 50 Hz
Power consumption: 2000 Watts (max)
Current: 9 Amps
Bionaire International B.V. reserves the right to change or modify any specifica-
tions without notice.
Installation of a plug
Applicable to U.K. and Ireland
The wires in the mains lead are coloured as such:
BROWN -
LIVE
BLUE -
NEUTRAL
Please note that the colour of these mains wires may not correspond with the
colour markings that identify the terminals in your plug. Please proceed as
follows:
The BROWN coloured wire must be connected to the terminal, which is
marked with the letter ‘IL” or is coloured RED.
The BLUE coloured wire must be connected to the terminal, which is marked
with the letter “N” or is coloured BLACK.
DO NOT CONNECT either of these wires to the earth terminal in the plug.
The earth terminal plug is marked with the letter “E”, or with the earth symbol,
or coloured GREEN, or GREEN and YELLOW.
NOTE: If the terminals in the plug are not marked or if you are unsure or in
doubt about the installation of the plug please contact a qualified electrician.

English:
Battery back-up:
The battery is already included in a sealed compartment and is not replaceable”.
French:
Option de piles:
La pile est deja indue dans un compartiment ferm4 hermitiquement et ne peut &re remplacee.
German:
Standby-bat-terie:
Die Batterie ist bereits in einem versiegeften Fach untergebracht und ist nicht austauschbar.
ftatian:
Alimentarione di resewa a batteria:
La batteria & giA indusa in uno scomparto sigillato e non & sostituibile.
Spanish:
Opcidn de pilas de reserva:
Las pilas ya estin incluidas en un compartimento precintado y no se
pueden recambiar.
Portugese:
Op@o para piiha reserva:
A piiha j4 estA indusa num compartimento lacrado e Co pode ser substituida.
Dutch:
Reservebatterij:
De batterijis al geinstalleerd en verzegeld,en is dus niet vervangbaar.
Swedish:
8atteriuppbackning:
Batten’et sitter redtin i ett fiirseglat fack och kan inte bytas ut.
Norwegian
Ekstrabatten’:
Batteriet er ailerede installert i et forseglet rom, og kan ikke skiftes ut.
Danish:
Batterier:
Batteriet findes allerede i et tillukket rum og kan ikke udskiftes
Finnish:
Pattereiifa:
Paristo sijaitsee jo vaimiinasuljetussa lokerossa, eik2I sit2 voida vaihtaa.
Polish:
Bateriq rezerwowq:
Bateria jest jut pod@zona do szczelnie zamknietego oddzialu i nie jest wymienialna.
Turkish:
Yedek pile ile:
Pi1 muhijriij kompartlman @erisindedir ve yerine baska pit konulamaz.