BJ ICONIC LIGHTS User manual

INSTALATION MANUAL
Thank you for purchasing BJ Iconic lights,
Here you will find a detailed manual with links to photos how to uninstall current angel lights from
headlights (in case you have a model with Angel eyes), and how to install new BJ Iconic lights. If you
need help, contact us and our technician will be at your disposal.
Team BIMMER Jakes
Instalation BJ Iconic lights for the following model:
Type of vehicle:
Pre-facelift

Type of
headlight:
Xenon
Model series:
BMW X5 F25
1) Remove headlights cover
Uninstall the original lights angel eyes. When installing the original lights, care should
be taken to exert greater force due to the fragility of the components. First, remove the
smaller ring by lifting the upper lever, see Figure n. 1. Then remove the ring from the
bottom side of lights where the part is only inserted.
Figure no. 1 - Uninstall a smaller ring
2) Then the larger ring is removed. The procedure to uninstall a larger ring is similar to
that of a small ring, with the difference that the upper bar is mounted under the plastic
light cover. It is necessary to lift it up with your hand, or use a flat-blade screwdriver
as shown in Figure 2. Next, lift the handle with a flat-blade screwdriver such as a
small ring (take extra care) and remove the ring from the bottom of the light.

Figure no. 2 - Uninstall larger ring
3) Installing Bimmer Iconic lights is similar to uninstalling the original rings. When
installing a small ring, insert the foot into the grooves in the bottom of the light, see
Fig. 3. Next, fix the light with the groove located on the back of the ring. Put the
groove on the protrusion located under the main light. Finally, attach the light to the
top of the light using a pawl, and the grooves formed on it (Take care and use fine
force) see Figure 4.
Fig. no. 3 - Small Ring Installation

Fig no. 4 - Attaching a small ring to the top of the light
4) Adding a larger ring The Bimmer Iconic lights work the same way as a small ring.
Insert the ring foot into the grooves provided at the bottom of the light cover and slide
the groove on the back of the Iconic lights onto the protrusion below the headlight.
The paws are caught by the protrusions on the top of the light cover, where the plastic
cover of the headlight must be carefully lifted, see Fig. 5.
Fif. no. 5 - Lift the light cover

Conection for F25 Xenon Pre- Facelift by H8