Black & Decker SM250 User manual

www.blackanddecker.ae SM250
AR PT FR EN

Parts Identification
1. Pusher
2. Feeding tube
3. Lid
4. Blade holder
5. Thin slicing blade
6. Thin grating blade
7. Thick slicing blade
8. Thick grating blade
9. Stirrer
10. Bowl
11. Spout
12. On/O knob
13. Chopper body
2
ENGLISH

3
ENGLISH
Intended use
Your Black & Decker appliance is intended
for chopping, grating and slicing various
ingredients. Do not use this appliance for
any other purpose. This product is intended
for indoor household, domestic use only.
Read this entire manual carefully
before using the appliance.
Safety instructions
Warning! When using mains-powered
appliances, basic safety precautions,
including the following, should always be
followed to reduce the risk of fire, electric
shock and personal injury.
• The intended use is described in this
manual. The use of any accessory or
attachment or the performance of any
operation with this appliance other than
those recommended in this instruction
manual may present a risk of personal
injury.
• Retain this manual for future reference.
Using your appliance
• Always take care when using the
appliance.
• Never pull the power supply cord to
disconnect the plug from the socket.
Keep the power supply cord away from
heat, oil and sharp edges.
• Do not place the appliance on or near
heat sources or in a heated oven.
• Do not use the appliance outdoors.
• Always protect the motor unit from
water or excessive humidity.
• If the power supply cord is damaged
during use, disconnect the appliance from
the power supply immediately. Do not
touch the power supply cord before
disconnecting from the power supply.
• Disconnect the appliance from the power
supply when not in use, before fitting or
removing parts and before cleaning.
• Never let the appliance operate
unattended.
• Never reach into the jar with your fingers
or an object while the appliance is
running.
• Only remove the jar after you have
switched the appliance o and any
moving parts have stopped.
• Do not touch the cutting blades.
• Keep any loose clothing or long hair away
from the feeding tube and any moving
parts.
• Care shall be taken when handling the
sharp cutting blades, emptying the bowl
and during cleaning.
• Do not let the cord hang over the edge of
a table, counter, or touch hot surfaces.
• Guide the power supply cord neatly so it
does not hang over the edge of a
worktop and cannot be caught
accidentally or tripped over.
• Misuse of the appliance could cause an
injury.
Keep hand away from the moving
parts. Do not approach the spout
when the appliance is running.

4
ENGLISH
Safety of others
• This appliance is not intended for use by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use
of the appliance by a person responsible
for their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
• Do not allow children or any person
unfamiliar with these instructions to use
the appliance.
• Do not allow children or animals to come
near the work area or to touch the
appliance or power supply cord. Close
supervision is necessary when the
appliance is used near children.
• Children should not be left unattended
while the fan is in use.
• It is not recommended that this product
is used by children.
• Never leave the appliance unattended
when in use.
After use
• Remove the plug from the socket before
leaving the appliance unattended and
before changing, cleaning or inspecting
any parts of the appliance.
• When not in use, the appliance should be
stored in a dry place. Children should not
have access to stored appliances.
Inspection and repairs
• Switch off the appliance before cleaning,
changing accessories or approaching
parts which move in use
• Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may aect
its operation.
• Do not use the appliance if any part is
damaged or defective.
• Do not use the appliance if the blade is
damaged.
• Have any damaged or defective parts
repaired or replaced by an authorised
repair agent.
• Before use, check the power supply cord
for signs of damage, ageing and wear.
• Do not use the appliance if the power
supply cord or mains plug is damaged or
defective.
• If the power supply cord or mains plug is
damaged or defective it must be
repaired by an authorised repair agent in
order to avoid a hazard. Do not cut the
power supply cord and do not attempt to
repair it yourself.
• Never attempt to remove or replace any
parts other than those specified in this
manual.
Electrical safety
Before use, check the mains voltage
corresponds to the voltage on the rating
plate.
This appliance is double
insulated in accordance with
EN 60335-2-14; therefore no earth
wire is required.

5
ENGLISH
• To avoid the risk of electric shock, do not
immerse the cord, plug or motor unit in
water or other liquid.
• Check that the supply voltage shown on
the rating plate of the appliance matches
that of your electrical system. Any
connection error will invalidate the
guarantee.
Mains plug replacement
If a new mains plug needs to be fitted:
• Safely dispose of the old plug
• Connect the brown lead to the live
terminal of the new plug
• Connect the blue lead to the neutral
terminal
• If the product is class I (earthed),
connect the green/yellow lead to the
earth terminal
Warning! If your product is class II double
insulated (only 2 wires in the cord set), no
connection is to be made to the earth
terminal
• Follow the fitting instructions supplied
with good quality plugs
• Any replacement fuse must be of the
same rating as the original fuse supplied
with the product
Assembly
The appliance should be
disconnected from the mains
supply before assembly.
1. Wash all detachable parts (see chapter
‘Maintenance and cleaning’).
2. Place the bowl (10) onto the chopper
body (13).
3. Lock the bowl in place by turning it
anti-clockwise.
4. Place the stirrer (9) onto the spindle in
the centre of the bowl (10)
Extra care should be taken when
handling or assembling the blades.
5. Fit a blade (5, 6, 7 or 8) into the blade
holder (4).
6. Insert the flat side of the blade (5, 6, 7 or
8) into the centre of the blade holder (4)

7. Press down the curved side of the blade
(5, 6, 7 or 8) into the outside of the
blade holder (4).
8. Place the blade holder (4) onto the
spindle on top of the stirrer (9).
9. Place the lid (3) on to the bowl (10) with
the feeding tube (2) away from the spout
(11) and lock it in place by turning it
anti-clockwise.
Note: The unit can be dis-assembled by
following the assembly instructions in
reverse.
Use
1. Place the appliance on a flat, stable
surface.
6
ENGLISH

7
ENGLISH
2. Fully assemble the chopper.
3. Connect it to the electricity supply.
4. Turn the on/off knob (12) to the on ‘I’
position to start the appliance.
5. Remove the pusher(1).
6. Feed the ingredients down the feeding
tube (2).
7. The pusher (1) can be used to guide
smaller ingredients onto the blade.
8. When finished, turn the on/off knob (12)
to the off ‘0’ position to stop the
appliance.
The appliance should be
disconnected from the mains
supply before removing the blade
holder.
The appliance will not operate
without the bowl lid fitted.
Do not operate the appliance
without the blade fitted.
The chopper should not be run for longer
than 2 minutes. After a continuous run of 2
minutes, the chopper should be allowed to
cool for at least 5 minutes before further
use.
Useful advice
• Place the appliance on a clean, flat work
surface.
• When chopping is complete disconnect
the appliance from the power socket.
Maintenance & cleaning
• Switch the appliance off, remove the plug
from the power socket and wait until the
blade has stopped rotating.
• The appliance is easier to clean if you do
so immediately after use.
• Do not use abrasive cleaning agents,
scourers, acetone, alcohol etc. to clean
the appliance.
• All removable parts can be cleaned in a
dishwasher.
• All removable parts can be cleaned with a
cleaning brush in warm water with some
washing-up liquid and rinse them under
the tap.
• Remove the dirty parts from the motor
unit.
• Clean the motor unit with a damp cloth.
Warning! Never immerse the motor unit in
water nor rinse it under the tap.
SM250
Voltage 220 – 240 Volts
Supply 50/60 Hz
Power consumption 200 W
Net Weight 1.4 Kg
Technical data

8
ENGLISH
Warranty
Black & Decker is confident of the quality of
its products and oers an outstanding
warranty.
This warranty statement is in addition to and
in no way prejudices your statutory rights.
The warranty is valid within the territories of
the Member States of the European Union
and the European Free Trade Area.
If a Black & Decker product becomes
defective due to faulty materials,
workmanship or lack of conformity, within
24 months from the date of purchase, Black
& Decker warranty to replace defective
parts, repair products subjected to fair wear
and tear or replace such products to ensure
minimum inconvenience to the customer
unless:
The product has been used for
trade, professional or hire
purposes;
The product has been subjected to
misuse or neglect;
The product has sustained damage
through foreign objects,
substances or accidents;
Repairs have been attempted by
persons other than authorised
repair agents or Black & Decker
service sta.
To claim on the warranty, you will need to
submit proof of purchase to the seller or an
authorised repair agent. You can check the
location of your nearest authorised repair
agent by contacting your local Black &
Decker oce at the address indicated in this
manual.
Alternatively, a list of authorised Black &
Decker repair agents and full details of our
after-sales service and contacts are available
on the Internet at: www.2helpU.com.
Protecting the environment
Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your Black &
Decker product needs replacement, or if it is
of no further use to you, do not dispose of it
with other household waste. Make this
product available for separate collection.
• Black & Decker provides a facility for
recycling Black & Decker products once
they have reached the end of their
working life. This service is provided free
of charge. To take advantage of this
service please return your product to any
authorised repair agent who will collect
them on our behalf.
• You can check the location of your
nearest authorised repair agent by
contacting your local Black & Decker
oce at the address indicated in this
manual. Alternatively, a list of authorized
Black & Decker repair agents and full
details of our after-sales service and
contact are available on the Internet at:
www.2helpU.com.

9
FRANÇAIS
Identification des pièces
1. Poussoir
2. Cheminée de remplissage
3. Couvercle
4. Porte-lame
5. Lame à émincer fin
6. Lame à râper fin
7. Lame à émincer gros
8. Lame à râper gros
9. Agitateur
10. Bol
11. Bec verseur
12. Bouton marche/arrêt
13. Bloc moteur du hachoir

10
Utilisation prévue
Votre appareil Black & Decker a été conçu
pour hacher, râper et émincer divers
ingrédients. Ne pas utiliser cet appareil à
d’autres fins. Cet appareil électroménager
est destiné à un usage domestique à
l’intérieur uniquement.
Lisez ce manuel attentivement
avant d’utiliser l’appareil.
Consignes de sécurité
Avertissement! Lorsqu’on utilise un appareil
électrique, il faut toujours respecter
certaines règles de sécurité fondamentales,
notamment les suivantes, afin de prévenir
les risques d’incendie, de décharges
électriques ou de blessures corporelles.
• Ce manuel décrit la manière d’utiliser cet
appareil. L’utilisation d’un accessoire ou
d’une fixation, ou l’utilisation de cet
appareil à d’autres fins que celles
recommandées dans ce manuel
d’instruction peut présenter un risque de
blessures corporelles.
• Conservez ce manuel pour un usage
ultérieur.
Utilisation de votre appareil
• Prenez toutes les précautions nécessaires
pendant l’utilisation de l’appareil.
• Ne tirez jamais sur le cordon
d’alimentation pour débrancher la fiche
de la prise. Gardez le cordon
d’alimentation éloigné de toute source
de chaleur, de zones graisseuses et de
bords tranchants.
• Ne placez pas l’appareil sur ou près de
sources de chaleur ou dans un four
chaud.
• N’utilisez pas l’appareil à l’extérieur.
• Protégez toujours le bloc moteur de l’eau
ou d’une humidité excessive.
• Si le cordon d’alimentation est
endommagé pendant l’utilisation,
débranchez immédiatement l’appareil. Ne
touchez pas au cordon d’alimentation
avant d’avoir débranché l’appareil.
• Débranchez l’appareil de l’alimentation
secteur lorsqu’il n’est pas utilisé, avant de
monter ou de démonter des éléments et
avant de le nettoyer.
• Ne laissez jamais fonctionner l’appareil
sans surveillance.
• Ne jamais mettre vos doigts ou un objet
dans le bol lorsque l’appareil est en
marche.
• Retirer le bol seulement après avoir éteint
l’appareil et l’arrêt complet de toutes les
pièces en mouvement.
• Ne pas toucher les lames de coupe.
• Tenir les vêtements amples et les cheveux
longs éloignés de la cheminée de
remplissage et des pièces en mouvement.
• Prendre des précautions lorsque vous
manipulez les lames tranchantes, pendant
que vous videz le bol et pendant le
nettoyage.
• Ne pas laisser le cordon pendre du plan
de travail ni toucher les surfaces chaudes.
• Disposer le cordon de manière à ne pas
pendre du plan de travail pour éviter qu’il
ne soit tiré par mégarde ou ne fasse
trébucher.
• Une utilisation non appropriée de cet
appareil pourrait causer des blessures
corporelles.
Tenir les mains à l’écart des pièces
en mouvement. Ne pas approcher
du bec verseur lorsque l’appareil
est en marche
FRANÇAIS