Black Box KV62-CBL User manual

STEP X - Name of Step
24/7 TECHNICAL SUPPORT AT 877.877.2269 OR VISIT BL ACKBOX.COM
KV62-CBL
2-PORT K VM
SWITCH, 4K
QUICK START GUIDE

STEP 1 - Introduction
OVERVIEW
The KV62-CBL is a 2-port DisplayPort USB
KVM switch with 2 sets of USB KVM & Audio/
Mic combo cables and a wired QuickSwitch
button for easy connection to your two
computers. It allows you to access, control,
boot and reboot two USB-enabled multimedia
computers with only one USB keyboard,
mouse, display, speaker set and microphone.
For easy and fast switching between two
computers, you can use the QuickSwitch
button.
The KV62-CBL DisplayPort USB cable KVM switch
offers USB 2.0 interface technology for plug-and-
play and hot-plug abilities. In addition to connect to
mouse or keyboard, those two USB 2.0 ports can
also be connected to other high-speed USB devices.
Users can enjoy maximum exibility and
convenience with its compact and one-piece
design.

STEP 2 - Installation
INSTALLATION STEPS
Take the cable KVM switch out of the box and
follow the steps below for installation.
1. Connect a monitor, USB keyboard, and USB
mouse to the respective consoles port on the
KVM front panel.
2. Connect the xed KVM/audio and mic cables
to a computer’s connectors. Connect another
set of cables to another computer.
Installation is completed. Now you can operate
the KVM switch immediately.
NOTE: Some older computers with USB interfaces
might need to manually enable the USB option
in the BIOS settings before you can use any USB
devices. If your USB interface does not work, check
the USB option status in the BIOS.

STEP 3 - Operation
There are two methods to control your KVM switch
for computer and audio/mic port selection: using
(1) QuickSwitch Button (a wired remote control) or
(2) Keyboard hotkeys.
1. QuickSwitch Button (a wired remote control):
The QuickSwitch button is a wired remote control
that allows you a direct switching control. Simply
press the button to toggle between two computers.
2. Keyboard Hotkeys: For keyboard hotkey
operation, refer to the Quick Reference Table below.
TABLE 1 . QUICK REFERENCE TABLE
COMMAND QUICK SWITCH BUTTON KEYBOARD HOTKEYS DESCRIPTION
Select PC Port Press the button to toggle
between the two computers. Scroll-Lock + Scroll-Lock Select PC Port
NOTE: Press each keystroke in a hotkey sequence within two seconds. Otherwise, the hotkey sequence will
not be valid.

STEP 4 - Application diagram
RoHS Compliant
Quick Switch Button
Computer 2
Computer 1
1.2 m
1.5 m

STEP X - Name of Step
COPYRIGHT 2018 BLACK BOX CORPORATION. ALL RIGHTS RESERVED.
KV62-CBL_REV1_4.5X4.5.PDF