Black Orchid Hydro-Box Installation guide

50cm x 50cm x 100cm
Assembly Instruction Manual
for

Tent Fabric
Splash tray fabric
Frame Corner joints (inc 1 spare)
Box Contents C
D
47cm
47cm
Pole
Pole
E
F
50cm
50cm
Pole
Pole
A40cm
Pole
B40cm
Pole

1
STEP
Tent Assembly Instructions
Create the Base of the frame using 4 corner joints, 2 A poles and 2 B poles
Please follow the instructions carefully

2
STEP
Tent Assembly Instructions
Push the poles into the corner joints
until the locking ball pops back out
into the hole
Please note the Black Plastic End Cap should
be on the top for the top of the frame.
The Black Plastic End Cap should
on the bottom for the corners in the
base of the frame.

3
STEP
Tent Assembly Instructions
With the base joined together, next make the top of the frame with the
other A and B poles
Create the base and the top of the tent frame

4
STEP
Tent Assembly Instructions
Add poles C to the bottom and D to the top.

5
STEP
Tent Assembly Instructions
Join together the base of the frame with
the top of the frame.
Then add poles E and F to the top as seen
in Step 6

6
STEP
Tent Assembly Instructions
Add poles E and F to the top of the frame

7
STEP
Tent Assembly Instructions
Unfold your tent and place the frame into the base

8
STEP
Tent Assembly Instructions
Make sure the bottom of tent
is fitted firmly around the frame
before lifting the top of the tent
onto the frame

9
STEP
Tent Assembly Instructions
Lift the top of the tent
fabric up and carefully
fit it around the top
of the frame
Next zip up the top and
bottom zips all the way
around sealing the tent
up.
Start from the back of the
tent with the top zip then
use the bottom zip to
complete the back,
continue the same with
the sides and finish with
the front where both zips
will meet up.

10
STEP
Tent Assembly Instructions
Add the splash tray in the bottom once complete