Bloomfield PW-106 User manual

POWER SUPPLY CORD
INSTALLATION INSTRUCTIONS
37102-1 REV (-)
INSTALLATION INSTRUCTIONS
HYDRO-SURGE WASHING UNIT
MODEL PW-106
WELLS/BLOOMFIELD * VERDI, NV
ELECTRICAL
MODEL VOLTS MOTOR AMPS POWER
CORD
PW-106 120 1/3 6.0 NEMA 5-15P
CUTOUT DETAILS PRODUCT DIMENSIONS
TO FABRICATE AND INSTALL:
1. Cut and/or drill holes as required in wash tank side,
as specified in cutout details.
2. Remove thumb screws which hold impeller cover to
scoop housing.
3. Remove nuts and bolts which hold scoop housing to motor.
4. Mount motor and scoop housing to wah tank using supplied nuts,
bolts and gasket. Note On-Off switch orientation.
5. Replace impeller cover on scoop housing using thumb screws.
6. Plug power supply cord in to appropriate receptacle.
SUPPLY
H/P
SCOOP
IMPELLER
COVER
WASH TANK
GASKET
MOTOR
NUTS & BOLTS
MOUNTING PLATE
IF TANK HAS RADIUS
AT BOTTOM, INCREASE
THIS DIMENSION BY
THE AMOUNT OF THE
RADIUS.
OVERFLOW DRAIN
(NOT SUPPLIED)
5 1/4
(133)
ÿ
4 1/16
(103)
2 1/32
(52)
4 1/16
(103)
2 1/32
(52)
3 3/8
(86)
10
(254) 8 3/4
(222)
2
(51)
10 1/4
(260)
3 3/16
(81) 11 1/2 (292)
3/8
(10)
ÿ 4X
4 1/16
(103)
ÿ
INCHES
(MM)