BLOTZ B15-MW-007 User manual

15mm Middle Eastern Building #7
B15-MW-007
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Middle Eastern Building #7 (B15-MW-007)
Remove the four walls of the building and the
base from the sprue.
Glue the four walls together as shown above and
attach them to the base.
Remove the three sets of steps the side and end
wall from the sprue.
Glue the end wall into place as shown.
Attach the three sets of steps so they form the
staircase.
Glue the side wall into place.
Remove the four roof supports and the door
from the sprue.
Glue the door behind the opening and attach the
supports by pushing the lugs through the holes in the
walls so that they stick out as shown above.

Glue the trapdoor to the roof and place (do not
glue) the roof on top of the roof supports.
The finished building.
B10-MW-001
10mm 3x2 Residential
Designed and made in the K.
This is a model kit and is not intended for
persons under 14 years old.
This kit consists of:
B10-MW-100: Foyer (2 sheets)
B10-MW-150: Middle (1 sheet)
B10-MW-200: Roof (1 sheet)
Please refer to the website for
assembly instructions.
Blotz
90 Fullers Avenue
Cricklade
SN6 6E
[email protected]
www.blotz.co.uk